Bridgeless SEPIC Rectifier With Unity Power Factor and Reduced Conduction Losses
Author:
- Esam H. IsmailEIEsam H. Ismail
- 31 October 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 56 (4) , 1147-1157
Abstract
In this paper, a new bridgeless single-phase AC-DC converter with an automatic power factor correction (PFC) is proposed. The proposed rectifier is based on the single-ended primary inductance converter (SEPIC) topology and it utilizes a bidirectional switch and two fast diodes. The absence of an input diode bridge and the presence of only one diode in the flowing-current path during each switching cycle result in less conduction loss and improved thermal management compared to existing PFC rectifiers. Other advantages include simple control circuitry, reduced switch voltage stress, and low electromagnetic-interference noise. Performance comparison between the proposed and the conventional SEPIC PFC rectifier is performed. Simulation and experimental results are presented to demonstrate the feasibility of the proposed technique.Keywords
This publication has 24 references indexed in Scilit:
- Optimizing the Design of Single-Stage Power-Factor CorrectorsIEEE Industrial Electronics Magazine, 2007
- A Novel Zero-Voltage-Switching PWM Boost Rectifier With High Power Factor and Low Conduction LossesIEEE Transactions on Industrial Electronics, 2005
- A Novel Single-Phase Soft-Switched Rectifier With Unity Power Factor and Minimal Component CountIEEE Transactions on Industrial Electronics, 2004
- A high performance single phase AC to DC rectifier with input power factor correction2002
- A new ZVS semiresonant high power factor rectifier with reduced conduction lossesIEEE Transactions on Industrial Electronics, 1999
- The discontinuous conduction mode Sepic and Cuk power factor preregulators: analysis and designIEEE Transactions on Industrial Electronics, 1997
- A new ZVS-PWM unity power factor rectifier with reduced conduction lossesIEEE Transactions on Power Electronics, 1995
- Circuit topologies for PWM boost rectifiers operated from 1-phase and 3-phase AC supplies and using either single or split DC rail voltage outputs1995
- Characterization of conducted noise generation for Sepic, Cuk and Boost converters working as power factor preregulators1993
- A new zero-ripple switching DC-to-DC converter and integrated magneticsIEEE Transactions on Magnetics, 1983