Development of Surface-Coated Polylactic Acid/Polyhydroxyalkanoate (PLA/PHA) Nanocomposites
Open Access
Abstract
This work reports on the design and development of nanocomposites based on a polymeric matrix containing biodegradable Polylactic Acid (PLA) and Polyhydroxyalkanoate (PHA) coated with either Graphite NanoPlatelets (GNP) or silver nanoparticles (AgNP). Nanocomposites were obtained by mechanical mixing under mild conditions and low load contents (<0.10 wt %). This favours physical adhesion of the additives onto the polymer surface, while the polymeric bulk matrix remains unaffected. Nanocomposite characterisation was performed via optical and focused ion beam microscopy, proving these nanocomposites are selectively modified only on the surface, leaving bulk polymer unaffected. Processability of these materials was proven by the fabrication of samples via injection moulding and mechanical characterisation. Nanocomposites showed enhanced Young modulus and yield strength, as well as better thermal properties when compared with the unmodified polymer. In the case of AgNP coated nanocomposites, the surface was found to be optically active, as observed in the increase of the resolution of Raman spectra, acquired at least 10 times, proving these nanocomposites are promising candidates as surface enhanced Raman spectroscopy (SERS) substrates.Keywords
Funding Information
- Ministerio de Economía y Competitividad (TEC2017-86102-C2-2R)
- Junta de Andalucía (TEP-946 INNANOMAT)
This publication has 42 references indexed in Scilit:
- Piezoelectric energy harvesting and charging performance of Pb(Zn1/3Nb2/3)O3–Pb(Zr0.5Ti0.5)O3 nanoparticle-embedded P(VDF-TrFE) nanofiber composite sheetsComposites Science and Technology, 2018
- Transparent Films Based on PLA and Montmorillonite with Tunable Oxygen Barrier PropertiesBiomacromolecules, 2012
- The synergetic effect of phenylphosphonic acid zinc and microfibrillated cellulose on the injection molding cycle time of PLA compositesCellulose, 2011
- Functional Composite Materials Based on Chemically Converted GrapheneAdvanced Materials, 2011
- Polymer nanocomposites based on functionalized carbon nanotubesProgress in Polymer Science, 2010
- Nanoscale particles for polymer degradation and stabilization—Trends and future perspectivesProgress in Polymer Science, 2009
- Influence of twin-screw extrusion conditions on the dispersion of multi-walled carbon nanotubes in a poly(lactic acid) matrixPolymer, 2008
- A critical appraisal of polymer–clay nanocompositesChemical Society Reviews, 2007
- Challenges and advances in nanocomposite processing techniquesMaterials Science and Engineering: R: Reports, 2006
- Mechanical properties of nylon 6-clay hybridJournal of Materials Research, 1993