Experimental and Numerical Investigation on Effects of Pin Diameter on Multi-Point Forming
Open Access
Abstract
Multi-point forming (MPF) is an advanced and flexible method to form sheet metal workpieces. Although there are studies investigating different aspects of this method, the studies on the effects of pin diameter on sheet and pin contact on MPF are insufficient. In this study, pins with diameters of 10, 12, and 14 mm were used to investigate the damage factor, effective stress distribution, and required forming loads of three forms of aluminum 1100 parts in finite element simulations. In addition, experimental works were conducted for the 12 mm pin and the forming loads and the thinning on the contact points of pin and formed sheet metal parts were compared with the simulations. The 14 mm pin forming provided the highest effective stress distributions and the damage factors of 0.448, 0.770, and 0.329 were obtained for form1, form2, and form3, respectively. The percentage errors between experimental works and simulations using 12 mm pin forming were calculated as 7.4, 5.1, and 2.4% for all forms 1 to 3. In conclusion, pin diameter was shown to have significant effects on the MPF process. Larger diameter pins resulted in higher loads and tearing of sheet metal.Keywords
Funding Information
- University of Gaziantep Scientific Research Projects Governing Unit (BAP) Gaziantep, Turkey (RM.21.01)
This publication has 19 references indexed in Scilit:
- The Effect of the Thickness-to-Die Diameter Ratio on the Sheet Metal Blanking ProcessStrojniški vestnik - Journal of Mechanical Engineering, 2017
- Research on the process of flexible blank holder in multi-point forming for spherical surface partsThe International Journal of Advanced Manufacturing Technology, 2016
- Surrogate-based multi-point forming process optimization for dimpling and wrinkling reductionThe International Journal of Advanced Manufacturing Technology, 2015
- The analyse on the process of multi-point forming for dish headJournal of Materials Processing Technology, 2007
- Principles and apparatus of multi-point forming for sheet metalThe International Journal of Advanced Manufacturing Technology, 2006
- Finite element simulation of multi-point sheet forming process based on implicit schemeJournal of Materials Processing Technology, 2005
- Influence of transverse normal stress on sheet metal formabilityInternational Journal of Plasticity, 2003
- Multi-point forming technology for sheet metalJournal of Materials Processing Technology, 2002
- Multi-point forming: a flexible manufacturing method for a 3-d surface sheetJournal of Materials Processing Technology, 1999
- Design and analysis of reconfigurable discrete dies for sheet metal formingJournal of Manufacturing Systems, 1998