Effect of Power and Stand-Off Distance on Plasma Sprayed Hydroxyapatite Coatings
- 2 December 2013
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 28 (12) , 1279-1285
Abstract
Plasma sprayed hydroxyapatite coatings were deposited onto mild steel substrates under several power and stand-off distance conditions. The microstructure of the coatings was observed and imaged using scanning electron microscopy (SEM). The crystal structure and crystallinity of the coatings were analyzed using X-ray diffraction (XRD). The Ca/P ratio of the coating was measured using energy dispersive X-ray spectroscopy (EDX). The deposition efficiency of the coatings was measured by weighing the substrate before and after coating. The porosity, surface roughness, and microhardness of the deposited coatings were characterized by using ImageJ, surface profilometer, and Vickers microhardness tester, respectively. The results indicated that microhardness and deposition efficiency increased with increasing power and stand-off distance. Porosity, surface roughness, and crystallinity decreased as the Ca/P ratio steadily decreased.Keywords
This publication has 31 references indexed in Scilit:
- Hydroxyapatite Matrix Composites by Hot Isostatic Pressing: Part 1. Alumina Fibre ReinforcedJournal of Biomimetics, Biomaterials and Tissue Engineering, 2012
- Hydroxyapatite coating on the Ti–35Nb–xZr alloy by electron beam-physical vapor depositionThin Solid Films, 2011
- Calcium Orthophosphates as Bioceramics: State of the ArtJournal of Functional Biomaterials, 2010
- Twenty-year results of the cementless Corail stemInternational Orthopaedics, 2010
- Effect of Spraying Parameters on Deposition Efficiency and Wear Behavior of Plasma Sprayed Alumina-Titania Composite CoatingsPlasma Science and Technology, 2009
- Reactive Plasma‐Aided RF Sputtering Deposition of Hydroxyapatite Bio‐implant CoatingsChemical Vapor Deposition, 2007
- Intrinsic residual stresses in single splats produced by thermal spray processesActa Materialia, 2001
- The use of hydroxyapatite in orthopaedic surgery: A ten-year reviewEuropean Journal of Orthopaedic Surgery & Traumatology, 1999
- Bioactive materialsCeramics International, 1996
- Thermal Spraying of Hydroxyapatite for Bioceramic ApplicationsKey Engineering Materials, 1991