Experimental Study of Reverse Flow Solar Air Heater Having Perforation and Delta Wing on Absorber Plate
Authors:
- 16 January 2024
- journal article
- research article
- Published by Wiley in Energy Technology
- Vol. 12 (4)
Abstract
FThe traditional solar air heater (SAH) has poor thermal performance due to low heat transfer coefficient. Artificial roughness, flow passage alteration, absorber modification, etc. can enhance it. Thus, an experimental investigation is performed to study the thermohydraulic characteristics of a reverse flow SAH with perforated absorber and delta wing (DW) structure. The present study investigates the effect of attack angle (15°–75°) at constant streamwise pitch (35 mm), transverse pitch (70 mm), height (h), and width (w) of DW 20 mm, under Reynolds number (Re) ranging from 4000 to 20 000. The perforation index (PI = ADW/Aap) for inline and staggered arrangements are 9.52 and 4.76, respectively. The results indicate that the concept of perforated absorber and DW leads to enhanced heat transfer, reduced pressure drops, and enhanced utilization of solar energy. The Nusselt number (Nu), friction factor (f), and thermohydraulic performance enhance about 6.6, 9.4, and 3.06 times, respectively, at attack angle 75o for inline arrangement of DW over the smooth duct. Thermohydraulic performance of reversed‐flow SAH is compared with previously published works, and it highlights that the full‐length inline and staggered arrangement of the DW offers the most significant improvements in heat transfer and friction factor.Keywords
This publication has 52 references indexed in Scilit:
- Analytical models of thermal performance of solar air heaters of double-parallel flow and double-pass counter flowRenewable Energy, 2013
- 3D simulation of laminar flow and heat transfer in V-baffled square channelInternational Communications in Heat and Mass Transfer, 2012
- An experimental investigation into the deployment of 3-D, finned wing and shape memory alloy vortex generators in a forced air convection heat pipe fin stackApplied Thermal Engineering, 2011
- Enhanced heat transfer in a triangular ribbed channel with longitudinal vortex generatorsEnergy Conversion and Management, 2010
- Experimental investigations on heat transfer and frictional characteristics of a turbulator roughened solar air heater ductInternational Journal of Heat and Mass Transfer, 2009
- Heat transfer and friction in solar air heater duct with V-shaped rib roughness on absorber plateInternational Journal of Heat and Mass Transfer, 2002
- Effect of collector aspect ratio on the collector efficiency of upward type baffled solar air heatersEnergy Conversion and Management, 2000
- Effect of artificial roughness on heat transfer and friction factor in a solar air heaterSolar Energy, 1988
- Optimization of Flow Passage Geometry for Air-Heating, Plate-Type Solar CollectorsJournal of Solar Energy Engineering, 1981
- Application of rough surfaces to heat exchanger designInternational Journal of Heat and Mass Transfer, 1972