Initial β Grain Size Effect on High-Temperature Flow Behavior of Tb8 Titanium Alloys in Single β Phase Field
Open Access
Abstract
The high-temperature flow behavior of TB8 titanium alloys with two different grain sizes was investigated in this present work. Results show that a significant characteristic of stress drop is visible at the start stage of the hot deformation process when the strain rates are 100 and 10−1 s−1. With the further increasing of strain, the flow stress initially rises to a maximum value and subsequently attains a plateau for the strain rates of 100 s−1 and a slight decrease for the strain rates of 10−1 s−1. Only dynamic recovery occurs under these deformation conditions. When the strain rates drop to 10−3 s−1, the dynamic recrystallization takes place during hot deformation. The values of deformation activation energy and materials constants at different strains were calculated. The processing maps at different strains were established for the fine- and coarse-grained alloys. The optimal processing parameter for hot processing was attained to be 900 °C/10−3 s−1 for fine-grained alloys and 950 °C/10−3 s−1 for coarse-grained alloys, respectively.Keywords
Funding Information
- National Natural Science Foundation of China (51804087)
This publication has 45 references indexed in Scilit:
- Characterization of high-temperature deformation behavior of as-cast Ti60 titanium alloy using processing mapMaterials Science and Engineering: A, 2013
- Characterization of the hot deformation behavior of a Ti–22Al–25Nb alloy using processing maps based on the Murty criterionIntermetallics, 2012
- Mechanical properties of Ti-6Al-4V specimens produced by shaped metal depositionScience and Technology of Advanced Materials, 2009
- Effect of initial grain size on dynamic recrystallization in high purity austenitic stainless steelsActa Materialia, 2005
- Influence of grain size on the compressive deformation of wrought Mg–3Al–1ZnActa Materialia, 2004
- Influence of grain size on hot working stresses and microstructures in Mg–3Al–1ZnScripta Materialia, 2004
- Deformation behaviour of beta titanium alloy Ti–10V–4.5Fe–1.5Al in hot upset forgingMaterials Science and Engineering: A, 2002
- Influence of oxygen content on the forging response of equiaxed (α+β) preform of Ti–6Al–4V: commercial vs. ELI gradeJournal of Materials Processing Technology, 2000
- On the flow localization concepts in the processing maps of titanium alloy Ti–24Al–20NbJournal of Materials Processing Technology, 2000
- Effect of Interpass Time and Cooling Rate on Apparent Activation Energy for Hot Working and Critical Recrystallization Temperature of Nb-microalloyed Steel.ISIJ International, 1999