Effect of Alloy Composition on the Glass Forming Ability in Ca-Mg-Zn Alloy System
- 15 January 2005
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 475-479, 3415-3418
Abstract
The effect of alloy composition on the glass forming ability (GFA) of the Ca-Zn-Mg alloys has been investigated in the present study. The alloy compositions investigated are near Ca-rich ternary eutectic composition; Ca60Mg15Zn25, Ca65Mg10Zn25, Ca65Mg15Zn20, Ca65Mg20Zn15, and Ca70Mg15Zn15. Bulk metallic glass (BMG) samples with the diameter larger than 5 mm are fabricated by conventional copper mold casting method in air atmosphere. Among the parameters representing the glass forming ability, Trg and γ parameters exhibit good correlation with the maximum diameter of the fully amorphous structure in the alloy compositions investigated in the present study.Keywords
This publication has 13 references indexed in Scilit:
- Fabrication of recyclable catalyst supports for synthesis of carbon nanofibersMetals and Materials International, 2004
- Formation of Ca–Mg–Zn bulk glassy alloy by casting into cone-shaped copper moldJournal of Materials Research, 2004
- Fabrication of ternary Mg–Cu–Gd bulk metallic glass with high glass-forming ability under air atmosphereJournal of Materials Research, 2003
- Ni-based bulk metallic glass formation in the Ni–Nb–Sn and Ni–Nb–Sn–X (X=B,Fe,Cu) alloy systemsApplied Physics Letters, 2003
- Effects of Ti on the Thermal Stability and Glass-Forming Ability of Ni-Nb Glassy AlloyMATERIALS TRANSACTIONS, 2002
- Formation, Thermal Stability and Mechanical Properties of Cu-Zr-Al Bulk Glassy AlloysMATERIALS TRANSACTIONS, 2002
- Formation and Thermal Stability of Ca-Mg-Ag-Cu Bulk Glassy AlloysMATERIALS TRANSACTIONS, 2002
- Formation, Thermal Stability and Mechanical Properties of Ca-Based Bulk Glassy AlloysMATERIALS TRANSACTIONS, 2002
- High-strength Cu-based bulk glassy alloys in Cu–Zr–Ti and Cu–Hf–Ti ternary systemsActa Materialia, 2001
- Mg–Cu–Y Bulk Amorphous Alloys with High Tensile Strength Produced by a High-Pressure Die Casting MethodMaterials Transactions, JIM, 1992