Mechanical behaviour of multi-layer half-cells of microtubular solid oxide fuel cells fabricated by the co-extrusion process
- 1 February 2016
- journal article
- research article
- Published by Elsevier in Ceramics International
- Vol. 42 (3) , 4194-4203
Abstract
No abstract availableKeywords
Funding Information
- Shiraz University (93-GR-ENG-16)
This publication has 14 references indexed in Scilit:
- Optimization of the rheology and sintering behavior of electrolyte and anode pastes to be used in co-extrusion of solid oxide fuel cellsJournal of the European Ceramic Society, 2015
- Recent fabrication techniques for micro-tubular solid oxide fuel cell support: A reviewJournal of the European Ceramic Society, 2015
- Strength and failure modes of ceramic multilayersJournal of the European Ceramic Society, 2012
- Co-extrusion of multilayered ceramic micro-tubes for use as solid oxide fuel cellsJournal of the European Ceramic Society, 2010
- A numerical tool to estimate SOFC mechanical degradation: Case of the planar cell configurationJournal of the European Ceramic Society, 2008
- Examination of wet coating and co-sintering technologies for micro-SOFCs fabricationJournal of Membrane Science, 2007
- Anode‐Supported Tubular Micro‐Solid Oxide Fuel CellInternational Journal of Applied Ceramic Technology, 2007
- Fabrication and Characterization of Tubular Solid Oxide Fuel CellsInternational Journal of Applied Ceramic Technology, 2007
- Design and characterisation of a co-extruder to produce trilayer ceramic tubes semi-continuouslyJournal of the European Ceramic Society, 2001
- Optimisation parameters for the extrusion of thin YSZ tubes for SOFC electrolytesJournal of the European Ceramic Society, 2000