Until recently, design and analysis of most concrete structures have been based on elastic or working stress theory. 1In this method, concrete and steel stresses under working load are limited to some fraction of their corresponding strengths and it is implied that the structure has the same factor of safety against failure. However, it is well known that concrete and steel are not elastic up to failure and there is no direct relationship between strength and deformation characteristics of the structure at working load and at ultimate. This has led to the development of today's ultimate strength theories where the non-linearity is acknowledged in section design,1but structural analysis still has to be carried out by elastic methods like moment distribution, slope deflection or computer systems such as “STRESS” or “STRUDL”, etc. Most recently a number of limit design or analysis methods have been proposed.2'3'4They fulfil the expectation of a continuity of thought in the concept of inelasticity from the sectional to the structural level. Yet their development is hampered by the lack of complete or realistic deformation models. Although all methods are based on the three principles of structural mechanics, i.e., equilibrium, compatibility and force-deformation relationship, their realism, complexity and calculation procedures are governed mainly by the deformation model chosen.