Tensile and Compressive Deformation of a Short-Glass-Fiber-Reinforced Liquid Crystalline Polymer
Authors:
- 1 July 1995
- journal article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 8 (3) , 304-322
Abstract
Results of tensile and compression tests on a short-glass-fiber-reinforced thermotropic liquid crystalline polymer are presented. The effect of strain rate on the compression stress-strain characteristics has been investigated over a wide range of strain rates e between 10-4 and 350 s'l. The low-strain-rate tests were conducted using a screw-driven universal tensile tester, while the high-strain-rate tests were carried out using the split Hopkinson pressure bar technique. The compression modulus was shown to vary with log10 (ė) in a bilinear manner. The compression modulus is insensitive to strain rate in the low-strain-rate regime (ė = 10-4 - 10-2 s-'), but it increases more rapidly with ė at higher ė. The compression strength changes linearly with log10 (ė) over the entire strain- rate range. The fracture surfaces were examined by scanning electron microscopy.Keywords
This publication has 19 references indexed in Scilit:
- Mechanical anisotropy and inhomogeneity of an aromatic liquid crystalline polyesterPolymer, 1992
- Tensile properties of filled liquid-crystal polymer systemsJournal of Materials Science Letters, 1992
- Ultrasonic measurements of the elastic moduli of liquid crystalline polymersPolymer, 1992
- Influence of fibre reinforcement on the mechanical anisotropy of liquid crystal polymersPolymer, 1991
- Impact behaviour of short fibre/liquid crystal polymer compositesComposites, 1989
- Production of ultrahigh-modulus liquid-crystal polymer rodsJournal of Polymer Science Part B: Polymer Physics, 1988
- Influence of short-fibre reinforcement on the fracture behaviour of a bulk liquid crystal polymerJournal of Materials Science, 1986
- Thermotropic polyester amide-carbon fiber compositesJournal of Applied Polymer Science, 1986
- Hierarchical structure in a thermotropic liquid-crystalline copolyesterJournal of Materials Science, 1986
- Injection molding of thermotropic liquid crystal polymersPolymer Engineering & Science, 1983