Some commentary on the choice of rotor bar material for induction motors
Authors:
- J.H. DymondJDJ.H. Dymond
- R.D. FindlayRFR.D. Findlay
- 1 January 1995
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 10 (3) , 425-430
Abstract
Almost any metal can be used in the design of the squirrel cage of an induction machine. Obviously lead is not used because of its low melting point and magnesium because of its low flash point. Others are rejected because of the cost, lack of strength, resistance, thermal conductivity, or manufacturability including ease of joining. Basically, the choice fails to two materials, aluminum and copper and their alloys. For lowest cost of manufacture, especially for mass production, aluminum surpasses copper. In order to determine which of the two materials is the best takes the combined skills of an electrical, a mechanical and a metallurgical engineer. This paper discusses some of the considerations in the choice of rotor bar material.Keywords
This publication has 6 references indexed in Scilit:
- Practical measurement of symmetrical component currents in induction motors1994
- Placement of vents to reduce shaft flux in two pole induction motors with a comment on heating effectsIEEE Transactions on Energy Conversion, 1992
- Analysis of rotor failures in squirrel-cage induction motorsIEEE Transactions on Industry Applications, 1988
- The Theory of Three Phase Induction Squirrel Cage MotorsElectric Machines & Power Systems, 1987
- Die Prüfung elektrischer Maschinen1987
- Fabricated Aluminum Cage Construction in Large Induction MotorsIEEE Transactions on Industry Applications, 1976