Mechanical Alloying of Zr–Fe Alloys Using Severe Plastic Deformation by High Pressure Torsion
- 1 February 2020
- journal article
- research article
- Published by Pleiades Publishing Ltd in Physics of Metals and Metallography
- Vol. 121 (2) , 150-156
Abstract
Alloys of Zr–Fe system with an iron content from 5 to 90 at % were synthesized from elemental powders using the method of mechanical alloying in Bridgman anvils. Their phase composition and structure were studied by X-ray diffraction and transmission electron microscopy. It was found that the grain size decreases with increasing both the iron content in the alloy and the degree of plastic deformation. The smallest grain size is observed in Zr–50 at % Fe alloy.Keywords
This publication has 21 references indexed in Scilit:
- Mechanical Alloying of Ti–Fe Alloys Using Severe Plastic Deformation by High-Pressure TorsionPhysics of Metals and Metallography, 2018
- Mechanical alloying of Al–Fe alloys using severe deformation by high-pressure torsionPhysics of Metals and Metallography, 2015
- Nanocrystalline Fe/Zr alloys: preparation by using mechanical alloying and mechanical milling processesHyperfine Interactions, 2011
- SYNTHESIS OF NANOCRYSTALLINE AND AMORPHOUS ALLOYS FROM ELEMENTARY POWDERS BY INTENSIVE PLASTIC DEFORMATION UNDER HIGH PRESSUREInternational Journal of Modern Physics B, 2010
- Magnetic properties of mechanically alloyed Fe100−xZrx(20 ⩽x⩽ 35) powderJournal of Physics D: Applied Physics, 2008
- Mechanical alloying of Ti-Ni alloys under high pressureScripta Materialia, 1999
- MECHANICAL ALLOYING OF THE Fe-Zr SYSTEM IN DIFFERENT MILLING CONDITIONSLe Journal de Physique Colloques, 1990
- Preparation of amorphous Fe-Zr alloys by mechanical alloying and melt spinning methodsJournal of Materials Science, 1989
- Formation and properties of mechanically alloyed amorphous FeZrMaterials Science and Engineering, 1988
- Mössbauer effect on mechanically alloyed Fe-Zr glassesJournal of Applied Physics, 1987