Background Superior biomechanical performance of tapered interference screws, in regard to reconstruction of anterior cruciate ligament (ACL), compared with non-tapered screws, has been reported in the literature. However, the effect of tapered interference screw’s body slope on the initial stability of ACL is not studied yet. Thus, the main goal of this study was to investigate the effects of interference screw's body slope on the initial stability of the reconstructed ACL. Methods Based on the best screw-bone tunnel diameter ratios in non-tapered screws, two different tapered interference screw were designed and fabricated. The diameters of both screws were considered to be equal to bone tunnel diameter in one third of their length from screw tip, then they were gradually increased by 1mm, in the lower slope (LSTIS), and 2 mm, in the higher slope (HSTIS) screws. To simulate the ACL reconstruction, sixteen soft tissue grafts were fixed, using HSTIS and LSTIS, in synthetic bone blocks. Through applying sub-failure cyclic incremental tensile load, graft-bone-screw construct's stiffness and graft laxity in each cycle, and through applying subsequent step of loading graft to the failure, maximum load to failure, and graft’s mode of failure were determined. Accordingly, performance of the fabricated interference screws were compared with each other. Results HSTIS, compared to LSTIS, provides a greater graft-bone-screw construct stiffness, and a lower graft laxity. Moreover, transverse rupture of graft fibers for LSTIS, and necking of graft in HSTIS group were the major types of grafts' failure. ConclusionHSTIS compared to LSTIS, by causing less damage in graft's fibers; reducing graft laxity; and increasing fixation stability, better replicates the intact ACL's behavior.