Reducing the effects of adhesion and friction in microelectromechanical systems (MEMSs) through surface roughening: Comparison between theory and experiments
Authors:
- 1 October 2005
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 98 (7) , 073528
Abstract
Due to the large surface-to-volume ratios and the low loads encountered in microelectromechanical systems (MEMSs), the surface forces become important and may lead to permanent adhesion and high friction between near contacting and contacting surfaces. The effect of these forces can be reduced through surface texturing (roughening) at the contact interface. Moreover, modifying the distribution of the contacting surface asperities so that it becomes positively asymmetric (unbalance between the peak and valley heights) and as peaky as possible (making slender asperities) reduces these forces even further. In the current study, the effects of these parameters, i.e., roughness, asymmetry, and peakiness, on reducing the adhesion and friction in polycrystalline silicon (also referred as polysilicon) MEMS surfaces, were theoretically and experimentally investigated. Polysilicon films with different levels of roughness, asymmetry, and peakiness were fabricated. The roughness characteristics of these films were used in a continuum-based micromechanics model to predict the level of adhesion and friction in actual MEMS devices. Experiments were also conducted to evaluate the adhesion pull-off force and friction coefficient associated with these films. It is found, both experimentally and theoretically, that the adhesion pull-off force and friction coefficient can be reduced by an order of magnitude by increasing the roughness, asymmetry, and peakiness of the contacting surfaces under low external normal forces. Stick-slip behavior, which may be indicative of the presence of adhesive forces, also reduces considerably with the increase of these parameters. Lastly, good agreement was found between simulations and experimental results. Thus, such a model could be used to determine the critical characteristics of a microstructure prior to fabrication to prevent adhesion and lower friction in terms of surface roughness, mechanical properties, and environmental conditions.Keywords
This publication has 23 references indexed in Scilit:
- Modeling the effect of skewness and kurtosis on the static friction coefficient of rough surfacesTribology International, 2004
- A Static Friction Model for Elastic-Plastic Contacting Rough SurfacesJournal of Tribology, 2004
- Integrated microrelays: concept and initial resultsJournal of Microelectromechanical Systems, 2002
- Contact physics of gold microcontacts for MEMS switchesIEEE Transactions on Components and Packaging Technologies, 1999
- A MEMS-based projection displayProceedings of the IEEE, 1998
- Effect of hydrogen termination on the work of adhesion between rough polycrystalline silicon surfacesJournal of Applied Physics, 1997
- Critical Review: Adhesion in surface micromechanical structuresJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1997
- Polysilicon surface-modification technique to reduce sticking of microstructuresSensors and Actuators A: Physical, 1996
- An Elastic-Plastic Model for the Contact of Rough SurfacesJournal of Tribology, 1987
- Contact of nominally flat surfacesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1966