Selective surface modification of SS304 using hybrid powder-mixed EDC process
- 1 January 2022
- journal article
- research article
- Published by SAGE Publications in Surface Engineering
- Vol. 38 (1) , 8-21
Abstract
The present study acclaims the influence of hybrid powders (MoS 2 +W) mixed dielectric fluid on the surface properties of SS304 by the electro-discharge coating (or EDC) process. Hard, wear-resistant, and lubricating surfaces are produced using different blending ratios of the powders infused in the dielectric liquid. The combined effect of both powders on the substrate's surface properties is studied. The process performance is evaluated in terms of wear analysis, surface roughness, coefficient of friction, micro-hardness, and compositional study at different peak current and duty factors. The experimental results show an aggregate increment of micro-hardness from 119.3% to 255.2% compared to substrate. The average surface roughness increases (2.69–4.32 μm) with an increase in tungsten content (from 5% to 50%) in the dielectric and decreases with MoS 2 content. The wear test results reveal a substantial decrease in coefficient of friction (COF = 0.104) with maximum concentration of MoS 2 and 0.274 for maximum tungsten.Keywords
This publication has 30 references indexed in Scilit:
- Duplex and Superduplex Stainless Steels: Microstructure and Property Evolution by Surface Modification ProcessesMetals, 2019
- Surface modification of Ti-alloy by micro-electrical discharge process using tungsten disulphide powder suspensionJournal of Manufacturing Processes, 2019
- Study on the Influence of Hybridized Powder Mixed Dielectric in Electric Discharge Machining of Alloy SteelsMaterials Today: Proceedings, 2018
- Mechanical performance of in-situ TiC-TiB 2 composite coating deposited on Ti-6Al-4V alloy by powder suspension electro-discharge coating processSurface and Coatings Technology, 2017
- Surface modification of 304 stainless steels to improve corrosion behavior and interfacial contact resistance of bipolar platesInternational Journal of Hydrogen Energy, 2016
- State of the art in powder mixed dielectric for EDM applicationsPrecision Engineering, 2016
- Improvement in Surface Characteristics by EDM with Chromium Powder Mixed FluidProcedia CIRP, 2016
- Surface modification of AISI H13 tool steel with silicon or manganese powders mixed to the dielectric in electrical discharge machining processThe International Journal of Advanced Manufacturing Technology, 2015
- Investigation of the Tool Wear Rate in Tungsten Powder-Mixed Electric Discharge Machining of AA6061/10%SiCpCompositeMaterials and Manufacturing Processes, 2015
- Investigating surface roughness, material removal rate and corrosion resistance in PMEDM of γ-TiAl intermetallicJournal of Manufacturing Processes, 2013