Photocatalytic degradation of azo pyridone dye: Optimization using response surface methodology
Open Access
- 1 March 2013
- journal article
- research article
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (13-15) , 2802-2812
Abstract
Response surface methodology (RSM) and central composite design have been applied to describe and optimize photocatalytic degradation of azo pyridone dye using TiO2, H2O2, and simulated sun light. The mutual interactions between three independent variables, viz. H2O2 concentration, irradiation time, and TiO2 content were obtained. The results revealed that the most influential variables under selected reaction conditions were irradiation time and TiO2 content. The optimized conditions for the photocatalytic degradation of azo pyridone dye were as follows: H2O2 concentration: 130.5 mg/L, irradiation time: 54.8 min, and TiO2 content: 2.48 g/L. Under these conditions, the maximum decolorization efficiency of 96.43% was achieved. This experimental value was in good agreement with the predicted one, which proved the validity of the model. Operation cost analysis indicated that irradiation time had the major influence on total process cost. The RSM based on the central composite design was shown to be a successful technique for the optimization of the decolorization efficiency of azo pyridone dye and can be very helpful in improving the process economic feasibility. TOC analysis showed that the dye could be effectively mineralized during photocatalytic degradation.Keywords
This publication has 29 references indexed in Scilit:
- Influence of process parameters on the photodegradation of synthesized azo pyridone dye in TiO2water suspension under simulated sunlightJournal of Environmental Science and Health, Part A, 2011
- TiO2-Assisted Photodegradation of Direct Blue 78 in Aqueous Solution in SunlightWater, Air, & Soil Pollution, 2010
- Combination of coagulation–flocculation and nanofiltration techniques for dye removal and water reuse in textile effluentsDesalination, 2010
- Response surface methodology applied for Orange II photocatalytic degradation in TiO2 aqueous suspensionsJournal of Chemical Technology & Biotechnology, 2008
- Adsorption of Direct Red 2 on bentonite modified by cetyltrimethylammonium bromideChemical Engineering Journal, 2008
- Statistical optimization of adsorption processes for removal of 2,4-dichlorophenol by activated carbon derived from oil palm empty fruit bunchesJournal of Environmental Sciences, 2007
- Photocatalytic degradation of Direct Yellow 12 dye using UV/TiO2 in a shallow pond slurry reactorDyes and Pigments, 2006
- TiO2-assisted photocatalytic degradation of azo dyes in aqueous solution: kinetic and mechanistic investigationsApplied Catalysis B: Environment and Energy, 2004
- Photocatalytic degradation of azo dye acid red 14 in water: investigation of the effect of operational parametersJournal of Photochemistry and Photobiology A: Chemistry, 2003
- Assessment of the importance of the role of H2O2 and O2o−in the photocatalytic degradation of 1,2-dimethoxybenzeneSolar Energy Materials and Solar Cells, 1995