Uncooled infrared thermal imaging sensor using vacuum-evaporated europium phosphor
Authors:
- 14 July 2015
- journal article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 25 (8)
Abstract
This paper reports an uncooled infrared (IR) thermal imaging sensor using europium phosphor, Eu(TTA) 3 , as a temperature-sensitive medium. An Eu(TTA) 3 thin film was evaporated and deposited on a thermally isolated microstructure made of SU-8. The temperature dependency of luminescence from Eu(TTA) 3 was used to convert the IR radiation power into visible-light intensity, which can be captured and digitized by a charge-coupled device (CCD) camera. The temperature coefficient of luminescence from the evaporated Eu(TTA) 3 was −2.1 ± 0.4% K −1 . Thermal images of a heater at 75−370 °C were acquired via a Ge lens. The minimum detectable temperature, noise-equivalent temperature difference (NETD), and thermal response time were measured as 75 °C, 2.66 K at 370 °C, and 0.2 s, respectively.Keywords
This publication has 23 references indexed in Scilit:
- Microthermomechanical infrared sensorsOpto-Electronics Review, 2014
- A Low-Cost 128 $\times$ 128 Uncooled Infrared Detector Array in CMOS ProcessJournal of Microelectromechanical Systems, 2008
- An uncooled optically readable infrared imaging detectorSensors and Actuators A: Physical, 2007
- Infrared detectors: status and trendsProgress in Quantum Electronics, 2003
- Amorphous-silicon-based uncooled microbolometer IRFPA1999
- Characterization and optimization of infrared poly SiGe bolometersIEEE Transactions on Electron Devices, 1999
- Chapter 6 Thermoelectric Uncooled Infrared Focal Plane Arrays1997
- Chapter 3 Monolithic Silicon Microbolometer Arrays1997
- Micromachined VO2-based uncooled IR bolometric detector arrays with integrated CMOS readout electronics1996
- Uncooled thermal imaging with monolithic silicon focal planes1993