Durable molybdenum oxide coated solid‐phase microextraction fiber for highly selective and efficient extraction of polycyclic aromatic hydrocarbons in water
Authors:
- 6 March 2019
- journal article
- research article
- Published by Wiley in Journal of Separation Science
- Vol. 42 (10) , 1878-1885
Abstract
A bonding method was developed for coating molybdenum oxides onto a steel wire substrate, which was used as a solid‐phase microextraction fiber, was coupled with gas chromatography. Based on the characterization, it is found that the as‐prepared molybdenum oxides material contained a nanobelt structure with a uniform size and good dispersibility. In addition, there were a large number of small protrusions on the surface of the nanobelts. These characteristics provided a large specific surface area for extraction. Molybdenum oxides exhibited a high extraction selectivity for polycyclic aromatic hydrocarbons owing to its moderate coordination. After the optimization of the factors, method detection limits of −1 were achieved, and the calibration curves were linear within the range of 2.0‐600 μg L−1. In addition, repeatability was demonstrated, and the RSD values were lower than 6.4%. The molybdenum oxides coating had a high scratch resistance, which could effectively prevent coating wear and failure. Combined with the high thermal and chemical stability, the service life of the coating was improved and could be used 150 times without a significant reduction in the extraction performance. Finally, the as‐prepared fiber had a comparable extraction capacity and higher partition coefficients that those of commercial polyacrylate fibers. This article is protected by copyright. All rights reservedKeywords
Funding Information
- National Natural Science Foundation of China (21665014)
This publication has 29 references indexed in Scilit:
- Hydrothermal synthesis of controlled morphologies of MoO3 nanobelts and hierarchical structuresMaterials Letters, 2015
- Hydrothermal fabrication of controlled morphologies of MoO3 with CTAB: Structure and growthMaterials Letters, 2015
- A review on procedures for the preparation of coatings for solid phase microextractionMicrochimica Acta, 2014
- Cobalt oxide nanoparticles as a novel high-efficiency fiber coating for solid phase microextraction of benzene, toluene, ethylbenzene and xylene from aqueous solutionsAnalytica Chimica Acta, 2014
- Head space solid phase microextraction based on nano-structured lead dioxide: Application to the speciation of volatile organoselenium in environmental and biological samplesJournal of Chromatography A, 2012
- Anodized aluminum wire as a solid-phase microextraction fiber for rapid determination of volatile constituents in medicinal plantAnalytica Chimica Acta, 2011
- Layer-by-Layer Fabrication of Chemical-Bonded Graphene Coating for Solid-Phase MicroextractionAnalytical Chemistry, 2011
- A novel TiO2 nanotube array/Ti wire incorporated solid-phase microextraction fiber with high strength, efficiency and selectivityJournal of Chromatography A, 2010
- A critical review in calibration methods for solid-phase microextractionAnalytica Chimica Acta, 2008
- Application of NiTi alloy coated with ZrO2 as a new fiber for solid-phase microextraction for determination of halophenols in water samplesAnalytica Chimica Acta, 2007