Effect of Annealing Temperature on Corrosion Behavior and ZrO2 Microstructure of Zircaloy-4 Cladding Tube
Authors:
- 1 January 1996
- book chapter
- Published by ASTM International
- p. 74-93
Abstract
This paper describes the corrosion behavior and the ZrO2 microstructure of Zircaloy-4 (Zry-4) cladding tubes that were intermediate annealed at various temperatures. The corrosion behavior of the cladding tubes was studied by autoclave tests performed under 633 K water condition and 673 K steam condition. A TEM examination shows that the microstructure of ZrO2 formed on the Zry-4 matrix consisted of both the columnar structure and the equiaxed grain. The grain size of the columnar grain was approximately 30 by 200 nm, while that of the equiaxed grain was less than 20 nm. The equiaxed grain was dominantly observed near lateral cracks and around intermetallic compounds that were incorporated into the ZrO2 film. An analysis of the HR-SEM images indicated that the equiaxed grain to columnar grain volume ratio increased with increasing weight gain, especially after the first transition. The equiaxed grain to the columnar grain volume fraction decreased with increasing annealing temperature, which corresponded to decreasing weight gain. It was suggested that grain boundary diffusion of oxygen ions was accelerated by grain-size change of the oxide owing to the ZrO2 microstructure transformation from the large columnar grains to the fine equiaxed grains. The ZrO2 microstructure transformation might be caused dominantly by the oxidation of the intermetallic precipitates. The intermetallic precipitates were fine and uniformly distributed in the low-temperature TREX annealed Zry-4. This resulted in high-temperature TREX annealing being beneficial for improving corrosion resistance of the Zry-4 tube in PWR environments.Keywords
This publication has 22 references indexed in Scilit:
- A theory of the resistance of Zircaloy to uniform corrosionJournal of Nuclear Materials, 1994
- The development of porosity in thick zirconia filmsJournal of Nuclear Materials, 1994
- 18 O tracer study of the oxidation of zircaloy‐4 in steamSurface and Interface Analysis, 1994
- How the Tetragonal Zirconia is Stabilized in the Oxide Scale that is Formed on a Zirconium Alloy Corroded at 400°C in Steam1994
- Microstructure of Oxide Layers Formed During Autoclave Testing of Zirconium Alloys1994
- On the Initial Corrosion Mechanism of Zirconium Alloy: Interaction of Oxygen and Water with Zircaloy at Room Temperature and 450°C Evaluated by X-Ray Absorption Spectroscopy and Photoelectron Spectroscopy1994
- Corrosion Behavior of Zircaloy-4 Sheets Produced Under Various Hot-Rolling and Annealing Conditions1994
- Precipitate evolution in the Zircaloy-4 oxide layerJournal of Nuclear Materials, 1992
- The Origin of the Cubic Rate Law in Zirconium Alloy OxidationJournal of the Electrochemical Society, 1975
- Diffusion of oxygen in growing zirconia filmsJournal of Nuclear Materials, 1968