The Electrochemical Machining Characteristics of Stainless Steels
Authors:
- 1 January 2003
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 150 (3) , D63-D69
Abstract
A systematic study of a variety of stainless steels [SS316, SS410, Jethete (J), Duplex (D), and Super Duplex (SD)] has been performed, measuring their electrochemical machining (ECM) characteristics in chloride and nitrate electrolytes. Theoretical current/time analysis using a segmented tool was used to determine the dissolution valencies, n, and overpotentials, V0,V0, along the flow path length. Electrolyte samples from the interelectrode gap, taken at intervals along the flow path, and the bulk were analyzed for conductivity, pH, and visible absorption. The results indicate that the ECM dissolution characteristics of stainless steels are controlled by the surface oxide structure, which is primarily determined by the chromium content. Typically, the high chromium steels D and SD were found to machine with high primary elemental valencies (consistent with nFe=3nFe=3 and nCr=6),nCr=6), resulting in the production of soluble CrO42−.CrO42−. However, for the low chromium steels J and SS410, low valency dissolution (consistent with nFe=2,nFe=2, nCr=3)nCr=3) occurred with chloride electrolyte, and this was also found for the intermediate chromium steel SS316 at low electrolyte flow and recycled electrolyte. These results have been explained by the disruption caused to the surface barrier oxide layer by chloride ions and solid ECM products, which allow low valency dissolution to take place. Significant accumulation of these products occurred when performing electrolyte recycling, which is commonly used in industry. © 2003 The Electrochemical Society. All rights reserved.Keywords
This publication has 23 references indexed in Scilit:
- Chemical Composition of Passive Films on AISI 304 Stainless SteelJournal of the Electrochemical Society, 1994
- On the determination of current efficiency in electrochemical machining with a variable gapJournal of Materials Processing Technology, 1993
- Electrochemical dissolution of stainless steels in flow channel cells with and without photoresist masksJournal of Applied Electrochemistry, 1990
- Critical Hydrodynamic Conditions for Disruption of Single Corrosion Pits on Stainless SteelJournal of the Electrochemical Society, 1986
- Formation of Salt Films during Anodic Metal Dissolution in the Presence of Fluid FlowJournal of the Electrochemical Society, 1983
- Economic study of electrochemical machiningInternational Journal of Machine Tool Design and Research, 1982
- Experimental Observations and Analysis of Hydrodynamic Effects on Growth of Small PitsCorrosion, 1981
- On the role of mass transport in high rate dissolution of iron and nickel in ECM electrolytes—II. Chlorate and nitrate solutionsElectrochimica Acta, 1980
- Temperature distribution along the gap in electrochemical machiningJournal of Applied Electrochemistry, 1977
- Analytic determination of the equilibrium electrode gap in electrochemical machiningInternational Journal of Machine Tool Design and Research, 1969