Dual Quasi-Resonant Controller Position Observer Based on High Frequency Pulse Voltage Injection Method
Open Access
- 20 November 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 213266-213276
Abstract
This paper proposed a dual quasi-resonant controller position observer for conventional pulsating high frequency voltage injection method. The proposed position observer can not only improve the dynamic performance of the sensorless control, but can also compensate the position error fluctuation caused by the dead-time effect. To improve the dynamic performance, the digital bandpass filter in the traditional position observer used to extract high frequency current response is replaced by a quasi-resonant controller firstly. Moreover, an improved Luenberger observer without lowpass filter, which is usually used in traditional position observer to filter the noise in speed information, is adopted in the new position observer. Therefore, dynamic performances can be improved. Then, to reduce the sixth harmonic in the magnitude of position error and speed error caused by the dead-time effect, a frequency adaptive quasi-resonant controller is connected in parallel with the proportional-integral controller in the Luenberger observer. The experiment results verify that the proposed observer can reduce the position estimation error not only in steady state operation conditions, but in variable speed and variable load conditions, and the speed variation range can be widened as well.Keywords
Funding Information
- National Natural Science Foundation of China (51677081, 51877099, 51777089)
- QingLan Project of Jiangsu Province
- Priority Academic Program Development of Jiangsu Higher Education Institutions
This publication has 25 references indexed in Scilit:
- Co-Reduction of Torque Ripple for Outer Rotor Flux-Switching PM Motor Using Systematic Multi-Level Design and Control SchemesIEEE Transactions on Industrial Electronics, 2016
- PMSM Sensorless Control by Injecting HF Pulsating Carrier Signal Into ABC FrameIEEE Transactions on Power Electronics, 2016
- Carrier Signal Injection-Based Sensorless Control for Permanent-Magnet Synchronous Machine Drives Considering Machine Parameter AsymmetryIEEE Transactions on Industrial Electronics, 2015
- Harmonic Analysis of the Effects of Inverter Nonlinearity on the Offline Inductance Identification of PMSMs Using High Frequency Signal InjectionJournal of Power Electronics, 2015
- Simple sensorless algorithm for interior permanent magnet synchronous motors based on high‐frequency voltage injection methodIET Electric Power Applications, 2014
- PMSM model for sensorless control considering saturation induced secondary saliencies2013
- Sensorless control with two types of pulsating high frequency signal injection methods for SPMSM at low speed2011
- Analysis and Compensation of Inverter Nonlinearity Effect on a Sensorless PMSM Drive at Very Low and Zero Speed OperationIEEE Transactions on Industrial Electronics, 2010
- A comparative analysis of pulsating vs. rotating vector carrier signal injection-based sensorless controlAPEC 07 - Twenty-Second Annual IEEE Applied Power Electronics Conference and Exposition, 2008
- Sensorless rotor position estimation of an interior permanent-magnet motor from initial statesIEEE Transactions on Industry Applications, 2003