Grain boundary versus particle stimulated nucleation in hot deformed Al–4·5Zn–1Mg alloy
- 1 May 2013
- journal article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 29 (5) , 517-528
Abstract
In the present research, an analytical model of recrystallisation combining grain boundary (GB) and particle stimulated nucleation (PSN) in hot deformed Al–4·5Zn–1Mg alloy was developed. The effects of evolving subgrain sizes and associated stored energy in addition to the Zener drag pressure on recrystallisation were incorporated into the model. A number of constants, fitting parameters and activation energies for recrystallisation nucleation were determined for the Al–4·5Zn–1Mg alloy by investigating recrystallisation after axisymmetric hot compression testing. It was found that with increasing temperature and decreasing strain rate, the number density of the nuclei decreased. Both GB and PSN played roles in the recrystallisation of this alloy. The temperature of subsequent annealing was found to be not strongly influential on the mode of recrystallisation, i.e. recrystallisation originated by GB nucleation or PSN. However, deformation conditions (strain, strain rate and temperature) clearly affected the mode of recrystallisation. Nucleation by the GB mechanism was especially marked. However, PSN played a dominant role in recrystallisation after deformation to large strains. In addition, when strain was −1 and the deformation temperature was higher than 450°C.Keywords
This publication has 20 references indexed in Scilit:
- An experimental and theoretical investigation of the formation of Zr-containing dispersoids in Al–4.5Zn–1Mg aluminum alloyMaterials Science and Engineering: A, 2010
- Optimization of the Chemical Composition and Homogenization Treatment of AA7020 Aluminum AlloyAdvanced Materials Research, 2010
- Correlation between Electrical Resistivity, Particle Dissolution, Precipitation of Dispersoids, and Recrystallization Behavior of AA7020 Aluminum AlloyMetallurgical and Materials Transactions A, 2009
- Coupling of a crystal plasticity finite-element model with a probabilistic cellular automaton for simulating primary static recrystallization in aluminiumModelling and Simulation in Materials Science and Engineering, 2000
- Microstructural modelling of aluminium alloys during thermomechanical processingMaterials Science and Engineering: A, 2000
- The influence of transient strain-rate deformation conditions on the deformed microstructure of aluminium alloy Al–1% MgActa Materialia, 1999
- Simulation of primary recrystallization using a modified three-dimensional cellular automatonActa Materialia, 1999
- Modeling the microstructural changes during hot tandem rolling of AA5XXX aluminum alloys: Part III. Overall model development and validationMetallurgical and Materials Transactions B, 1998
- Microstructure and local crystallographic evolution in an Al1 wt% Mg alloy deformed at intermediate temperature and high strain-rateActa Materialia, 1996
- RECRYSTALLIZATION TEXTURES1995