Finding an effective solution to seal-off perforations. whether it be to reduce gas flow, reduce water cut. or to modify injection profiles. has long been a subject of concern. Several solutions for through tubing shut-off have been tried with a varying level of success After 3 years of testing a new technology has been developed to manufacture a composite sleeve using elastomers. fibres and thermo-setting resins. The sleeve is run-in on electric wireline, inflated to push the composite against the inside of the casing, then heated to polymerise the resins. The running equipment is extracted to leave a pressure resistant inner lining in place. There is little diameter loss, leaning access to the well below, and opening up applications for tubing repair. Following successful field trials commercial operations have begun. Introduction: Composite material are generally composed of reinforced fibres such as glass, carbon or steel bedded in a matrix. The fibres generally provide the majority of the strength and the matrix serves to maintain them in place and to transfer the stresses to them. The matrices used may be soft or rigid :flexible matrices can be used for deformable products When this is the case, the matrix is mainly an elastomer. It has almost nothing to do with the mechanical strength, but acts solely as a binder for the fibres (protection, seal), Among other applications, some examples are various types of seals, car tires, membranes, etc.Rigid matrices form products that are not deformable and provide a degree of strength to the composite material. especially in the crosswise direction of the fibres. Fibreglass boats, fibreglass easing, are common examples. Very generally. a product is used either in a flexible and hence deformable state or else in a rigid and hence unreformable state. Using the deformability properties of a composite material with a thermo setting matrix in its unpolymerised state, while preserving its great mechanical properties obtained after polymerisation has several advantages. The crosslinking of the resin occurs directly at the place where the end product will be used. and not dring manufacturing as it is usually the ease. This means the composite can be shaped to the desired form in the wel1.and opens up a multitude of potential applications. For example composite easing can be manufactured in lengths of up to 1,000 meters and enable mono-diameter well to be designed with considerable savings. The first available application of this technology is the Patch-Flex, designed for remedial applications. A short composite tube manufactured with thermosetting resins is run on electric wireline opposite the zone to be treated. It is inflated and polymerised to leave a self supporting cylindrical lining3 (Fig. 1). Operating Principles: Product and Equipment. Run and set in electric wireline (Fig. 1 and 2) The Patch-Flex itself is composed of two principle parts (Fig. 3).