Synergistic influence of controlled solidification and T6 heat treatment on multiscale microstructural evolution and mechanical behaviour of A356 aluminium alloy
Authors:
- Shalini BhardwajSBShalini Bhardwaj
- Ashok SharmaASAshok Sharma
- B.S.S. DanielBDB.S.S. Daniel
Preprint
- 6 April 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
A356 aluminium alloy is widely used in automotive and aerospace applications; however, its mechanical performance in the as-cast condition is often limited by coarse α-Al dendrites and needle-shaped eutectic. In the present work, the synergistic effects of the modified processing route, i.e. controlled solidification and T6 heat treatment, on the multiscale microstructural evolution and mechanical properties of A356 aluminium alloy are systematically investigated. Conventional gravity casting resulted in a coarse microstructure characterized by large secondary dendrite arm spacing (SDAS), a degenerate eutectic with needle/plate-like morphology and pronounced strain inhomogeneity arising from localized dislocation pileups. Controlled solidification led to significant refinement of SDAS, suppressing facetted Si growth and strain localization. Subsequent T6 heat treatment further spheroidizes eutectic Si, promotes dislocation rearrangement, strain redistribution and formation of fine, uniformly distributed β″ (Mg₂Si) precipitates. The modified processing route produced a structurally homogenous microstructure, leading to improvements in hardness (~41%), local nanoindentation hardness (~39%), yield strength (~81%), and ultimate tensile strength (~86%) without compromising ductility (3.1 → 4.2%), consistent with fractographic observations. Quantitative evaluation of strengthening mechanisms reveals a transition from dislocation pile-up–controlled and solid-solution strengthening in the as-cast alloy to precipitation-assisted strengthening in the modified alloy. The present work advances understanding by providing a comprehensive, quantitative, and multiscale correlation between microstructural evolution and mechanical behaviour.Keywords
This publication has 48 references indexed in Scilit:
- Fluidity and Hot Cracking Susceptibility of A356 Alloys with Sc AdditionsTransactions of the Indian Institute of Metals, 2018
- Comparison of Measurement Methods for Secondary Dendrite Arm SpacingMetallography, Microstructure, and Analysis, 2017
- EBSD and DTA Characterization of A356 Alloy Deformed by ECAP During Reheating and Partial Re-meltingMetallurgical and Materials Transactions A, 2013
- Precipitation and Hardening in Magnesium AlloysMetallurgical and Materials Transactions A, 2012
- Solidification and Crystallization Processing in Metals and Alloys2012
- Precipitation-hardening in cast AL–Si–Cu–Mg alloysJournal of Materials Science, 2010
- A mechanism for the poisoning effect of silicon on the grain refinement of Al–Si alloysActa Materialia, 2007
- Spinodal decomposition in a film with periodically distributed interfacial dislocationsActa Materialia, 2004
- Faceted solidification morphologies in low-growth-rate Al-Si eutecticsJOM, 2004
- Geometrically necessary, incidental and subgrain boundariesScripta Metallurgica et Materialia, 1991