Effects of Annealing and Deformation on Sagging Resistance of a Hot‐Rolled, Four‐Layered Al Alloy Clad Sheet
Open Access
- 1 January 2021
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2021 (1)
Abstract
Multilayer brazeable aluminum alloy sheet is prone to collapse during high‐temperature brazing process. The sagging resistance of the aluminum composite sheet needs to be further improved for quality control. Effects of annealing and rate of reduction on sagging resistance, microstructure, and Si diffusion of a hot‐rolled, four‐layered Al clad sheet (4343/3003/6111/3003) were investigated by means of a sagging device, OM, SEM, and TEM. Results showed that once annealed at 360°C, the sagging distance was increased from 3 to 15.7 mm as the reduction rate changed from 10% to 40%. By increasing annealing temperature to 410°C, those were changed from 3.1 to 20.8 mm accordingly. At 360°C/40% and 410°C/40%, specimens exhibited weak sagging resistance, whereas fine recrystallized grains were formed in the core promoting Si penetration along grain boundaries. While the specimens were treated at 360°C/10% and 410°C/10%, better sagging resistance was observed due to the formation of coarse recrystallized grains that can suppress erosion of Si. At the same reduction rate, the sagging resistance was higher for the sample annealed at a lower temperature as more precipitates appeared in the core (at 360°C), thus leading to an increase in strength.Keywords
Funding Information
- National Natural Science Foundation of China (51705539)
This publication has 19 references indexed in Scilit:
- Effect of Microstructure on Diffusional Solidification of 4343/3005/4343 Multi-Layer Aluminum Brazing SheetMetallurgical and Materials Transactions A, 2012
- Recrystallization behavior of a supersaturated Al–Mn alloyMaterials Letters, 2010
- Effects of Si Content and Cold Rolling Condition on Brazeability of Al-Mn-Zn Alloy Core Brazing SheetMaterials Science Forum, 2005
- Optimizing homogenization parameters for better stretch formability in an Al–Mn–Mg alloy sheetMaterials Science and Engineering: A, 2005
- Fabrication and Sagging Behavior of Three-Layer Al-Si/Al-Mn-Zn/Al-Si Clad Sheets for Automotive Heat ExchangerMaterials Science Forum, 2003
- Evolution of eutectic intermetallic particles in DC-cast AA3003 alloy during heating and homogenizationMaterials Science and Engineering: A, 2003
- Brazeability of cold rolled three layer Al–7.5Si/Al–1.2Mn–2Zn–(0.04–1.0)Si/Al–7.5Si (wt.%) clad sheetsJournal of Materials Processing Technology, 2002
- Fabrication and brazeability of a three-layer 4343/3003/4343 aluminum clad sheet by rollingJournal of Materials Processing Technology, 2001
- The Mechanism of Braze Metal Penetration by Migration of Liquid Films in AluminiumMaterials Science Forum, 2000
- Recent development in aluminium alloys for the automotive industryMaterials Science and Engineering: A, 2000