Seismic Behavior of Post-Tensioned Gravity Dams: Shake Table Experiments and Numerical Simulations
- 1 February 2002
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 128 (2) , 140-152
Abstract
Displacement controlled shear tests on small concrete lift joint specimens with different surface roughnesses reinforced with an unbonded post-tension cable are conducted to study a related joint constitutive model, and to determine the failure mechanisms associated to it. To investigate the applicability of the joint model, shake table tests are conducted on a 3.4-m high plain concrete post-tensioned gravity dam that has a cold lift joint about midheight. Numerical simulations using the joint constitutive model are compared with the experimental results. From the displacement controlled shear tests, it is shown that the post-tension cable provides additional strength to the joint by applying an additional normal load on the joint, and by the shear resistance that can be mobilized (cable dowel action). The tests performed on rough surface joints have demonstrated that the dilatancy phenomenon due to asperities increases the post-tension force. Shake table tests on the 3.4-m high dam model have shown that post-tensioning largely reduces residual sliding displacements of the joint. This reduction is a function of the frequency content of the base excitation. However, a single post-tension cable placed near the upstream face increases the upstream rocking response of the upper block, which is also a function of the frequency content of the excitation. Strong seismic excitations can induce cable failure at a lower value than its uniaxial tensile strength when significant shear displacements take place. To describe this brittle failure mechanism, a cable failure criterion that considers the mobilized shear and tensile strengths was proposed and was found to be adequate. Moreover, the post-tensioned joint model proposed showed good agreement with the static and dynamic tests performed to evaluate the joint shear force.Keywords
This publication has 12 references indexed in Scilit:
- Static and Dynamic Behavior of Concrete Lift Joint InterfacesJournal of Structural Engineering, 1998
- AN INVESTIGATION INTO THE BASE SLIDING RESPONSE OF RIGID CONCRETE GRAVITY DAMS TO DYNAMIC LOADINGEarthquake Engineering & Structural Dynamics, 1996
- An experimental investigation into earthquake‐induced failure of medium to low height concrete gravity damsEarthquake Engineering & Structural Dynamics, 1995
- Sliding motion of anchored rigid block under random base excitationsProbabilistic Engineering Mechanics, 1994
- Toppling of Computer‐Type Equipment under Base ExcitationJournal of Engineering Mechanics, 1993
- Earthquake‐Induced Base Sliding of Concrete Gravity DamsJournal of Structural Engineering, 1991
- Shaking table study of concrete gravity dam monolithsEarthquake Engineering & Structural Dynamics, 1991
- ALKALI-SILICA REACTION: VAL DE LA MARE DAM, JERSEY, CASE HISTORY.Proceedings of the Institution of Civil Engineers, 1988
- A simple numerical representation of fully bonded passive rock reinforcement for hard rocksComputers and Geotechnics, 1985
- The shear strength of rock joints in theory and practiceRock Mechanics and Rock Engineering, 1977