Clinical value of patient-specific three-dimensional printing of congenital heart disease: Quantitative and qualitative assessments
Open Access
- 21 March 2018
- journal article
- research article
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 13 (3) , e0194333
Abstract
Current diagnostic assessment tools remain suboptimal in demonstrating complex morphology of congenital heart disease (CHD). This limitation has posed several challenges in preoperative planning, communication in medical practice, and medical education. This study aims to investigate the dimensional accuracy and the clinical value of 3D printed model of CHD in the above three areas. Using cardiac computed tomography angiography (CCTA) data, a patient-specific 3D model of a 20-month-old boy with double outlet right ventricle was printed in Tango Plus material. Pearson correlation coefficient was used to evaluate correlation of the quantitative measurements taken at analogous anatomical locations between the CCTA images pre- and post-3D printing. Qualitative analysis was conducted by distributing surveys to six health professionals (two radiologists, two cardiologists and two cardiac surgeons) and three medical academics to assess the clinical value of the 3D printed model in these three areas. Excellent correlation (r = 0.99) was noted in the measurements between CCTA and 3D printed model, with a mean difference of 0.23 mm. Four out of six health professionals found the model to be useful in facilitating preoperative planning, while all of them thought that the model would be invaluable in enhancing patient-doctor communication. All three medical academics found the model to be helpful in teaching, and thought that the students will be able to learn the pathology quicker with better understanding. The complex cardiac anatomy can be accurately replicated in flexible material using 3D printing technology. 3D printed heart models could serve as an excellent tool in facilitating preoperative planning, communication in medical practice, and medical education, although further studies with inclusion of more clinical cases are needed.Keywords
Funding Information
- National Key R&D Program of China (2016YFC1300300)
- Natural Science Foundation of China (CN) (81641069 and 81271542)
- National Heart Foundation of Australia (101843)
This publication has 38 references indexed in Scilit:
- 3D printed models for planning endovascular stenting in transverse aortic arch hypoplasiaCatheterization and Cardiovascular Interventions, 2015
- Incorporating Three-dimensional Printing into a Simulation-based Congenital Heart Disease and Critical Care Training Curriculum for Resident PhysiciansCongenital Heart Disease, 2014
- Three-dimensional printing in cardiac surgery and interventional cardiology: a single-centre experienceEuropean Journal of Cardio-Thoracic Surgery, 2014
- Utilizing Three-Dimensional Printing Technology to Assess the Feasibility of High-Fidelity Synthetic Ventricular Septal Defect Models for Simulation in Medical EducationWorld Journal for Pediatric and Congenital Heart Surgery, 2014
- Three-dimensional patient-specific cardiac model for surgical planning in Nikaidoh procedureCardiology in the Young, 2014
- Simulative operation on congenital heart disease using rubber-like urethane stereolithographic biomodels based on 3D datasets of multislice computed tomography☆European Journal of Cardio-Thoracic Surgery, 2009
- The practical clinical value of three-dimensional models of complex congenitally malformed heartsThe Journal of Thoracic and Cardiovascular Surgery, 2009
- Use of Rapid Prototyping in the Care of Patients with Structural Heart DiseaseTrends in Cardiovascular Medicine, 2008
- Physical Models Aiding in Complex Congenital Heart SurgeryThe Annals of Thoracic Surgery, 2008
- Stereolithographic Models for Surgical Planning in Congenital Heart SurgeryThe Annals of Thoracic Surgery, 2007