Frosting performances of the metal heat-transfer surface for the air-source heat pump in Harbin
- 20 June 2023
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
The frost formation on the metal heat-transfer surface of the air-source heat pump system dramatically weakens the system heating capacity. In this study, a frost formation experimental system based on the metal heat-transfer surface was implemented in the severely cold region of China, Harbin. The frosting performances including frost layer thickness and mass as affected by the ambient temperature, metal-surface temperature, and relative humidity were compared and analyzed, and the Response Surface Method was applied to analyze the significance degrees of experimental parameters. The results reveal that when the ambient temperature gradually decreased from 4 °C to -10 °C, the frost layer thickness and mass on the copper surface decreased. When the metal-surface temperature gradually decreased from -10 °C to -25 °C, the thickness and mass of the frost layer on the copper surface gradually increased. When the relative humidity gradually rose from 50% to 90%, the thickness and mass of the frost layer on the copper surface increased. The significance rank of experimental parameters for the frost layer mass was the metal-surface temperature > humidity > ambient temperature.Keywords
Funding Information
- National Natural Science Foundation of China
This publication has 10 references indexed in Scilit:
- A numerical study on frosting and its early stage under forced convection conditions with surface and environmental factors consideredSustainable Energy Technologies and Assessments, 2021
- Frost growth behavior according to the cold surface inclination angleInternational Journal of Heat and Mass Transfer, 2020
- Frost layer growth behavior under cryogenic conditionsApplied Thermal Engineering, 2019
- Experimental and numerical investigations of frost formation on wavy platesApplied Thermal Engineering, 2018
- The behavior of frost layer growth under conditions favorable for desublimationInternational Journal of Heat and Mass Transfer, 2018
- Frost formation and development on flat plate: Experimental investigation and comparison to predictive methodsExperimental Thermal and Fluid Science, 2017
- Frosting model based on phase change driving forceInternational Journal of Heat and Mass Transfer, 2017
- Frost formation on a vertical plate in simultaneously developing flowExperimental Thermal and Fluid Science, 2002
- Study of free convection frost formation on a vertical plateExperimental Thermal and Fluid Science, 2002
- Frost deposition in a parallel plate channel under laminar flow conditionsInternational Journal of Thermal Sciences, 2000