Mist/Steam Heat Transfer in Confined Slot Jet Impingement
Authors:
- 1 February 2000
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 123 (1) , 161-167
Abstract
Internal mist/steam blade cooling technology has been considered for the future generation of Advanced Turbine Systems (ATS). Fine water droplets of about 5 μm were carried by steam through a single slot jet onto a heated target surface in a confined channel. Experiments covered Reynolds numbers from 7500 to 25,000 and heat fluxes from 3 to 21 kW/m2. The experimental results indicate that the cooling is enhanced significantly near the stagnation point by the mist, decreasing to a negligible level at a distance of six jet widths from the stagnation region. Up to 200 percent heat transfer enhancement at the stagnation point was achieved by injecting only ∼1.5 percent of mist. The investigation has focused on the effects of wall temperature, mist concentration, and Reynolds number.Keywords
This publication has 16 references indexed in Scilit:
- Mist/Steam Cooling in a 180-Degree Tube BendJournal of Heat Transfer, 2000
- Mist/Steam Cooling in a Heated Horizontal Tube—Part 2: Results and ModelingJournal of Turbomachinery, 1999
- Mist/Steam Cooling in a Heated Horizontal Tube—Part 1: Experimental SystemJournal of Turbomachinery, 1999
- Experimental Study of Deformation Mechanism of a Water Droplet Impinging on Hot Metallic Surfaces Above the Leidenfrost TemperatureJournal of Fluids Engineering, 1997
- Cooling of a superheated surface with a jet mist flowInternational Journal of Heat and Mass Transfer, 1996
- Deformation and Rebounding Processes of a Water Droplet Impinging on a Flat Surface Above Leidenfrost TemperatureJournal of Fluids Engineering, 1996
- Interaction of a dilute mist flow with a hot bodyInternational Journal of Heat and Mass Transfer, 1995
- Cooling of a Heated Surface by Mist FlowJournal of Heat Transfer, 1994
- Heat Transfer in Two-Component Dispersed FlowJournal of Heat Transfer, 1981
- The heat transfer from a hot wall to impinging mist droplets in the spheroidal stateChemical Engineering Science, 1966