Challenging choice of safety factor for design of strip footings on gypsum-rich soils
Open Access
- 19 May 2020
- journal article
- research article
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 5 (2) , 1-6
Abstract
A fine-grained gypsum-rich clayey soil having a gypsum content of 33% is subjected, in CBR moulds, to modified American association of state highway and transportation officials compaction at optimum moisture content. Two sets of samples were prepared. The first set remained unsoaked, while the second was soaked in fresh water for 120 days. From each CBR sample, three specimens were extracted for unconsolidated undrained triaxial test and the Mohr–Coloumb failure envelopes were obtained for soaked and unsoaked conditions. Soaked samples suffered a significant drop in both cohesion and angle of internal friction. The ultimate bearing capacity of a strip footing was calculated for each of soaked and unsoaked conditions revealing the critical region. For important structures on gypsum-rich soil, the paper shows that the allowable bearing capacity should be based on soaked condition. Based on unsoaked conditions, a safety factor of 8 is required to assure a safety factor of 3 based on soaked condition. For less important structures in regions of hot dry climate with low probability of soaking, safety factors of 4 and 3, based on unsoaked conditions, are required to give safety factors of 1.5 and 1.1 based on soaked conditions, respectively.Keywords
This publication has 15 references indexed in Scilit:
- Frequency effect of cyclic soaking and drying on the resilient modulus of gypsum-rich roadbed sandTransportation Geotechnics, 2016
- Improving fine-grained gypsiferous soil by increased compactionInternational Journal of Pavement Engineering, 2012
- Effect of soaking period and surcharge load on resilient modulus and California bearing ratio of gypsiferous soilsQuarterly Journal of Engineering Geology and Hydrogeology, 2004
- Road and bridge construction across gypsum karst in EnglandEngineering Geology, 2002
- Decrease in the CBR of a gypsiferous soil due to long-term soakingQuarterly Journal of Engineering Geology, 1999
- Lime‐Induced Heave in Sulfate‐Bearing Clay SoilsJournal of Geotechnical Engineering, 1988
- Salt heaving in the SaharaGéotechnique, 1985
- The influence of ground and groundwater geochemistry on construction in the Middle EastQuarterly Journal of Engineering Geology, 1985
- Design of foundations of dams containing soluble rocks and soilsQuarterly Journal of Engineering Geology, 1980
- Gypsum and anhydrite in foundations of hydraulic structuresGéotechnique, 1978