Isolating the Oxygen Adsorption Defects on Sputtered Tin Oxide for Efficient Perovskite Solar Cells
- 2 May 2023
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (19) , 23518-23526
Abstract
Tin oxide (SnO2) is the most commonly used electron transport material for perovskite solar cells (PSCs). Various techniques have been applied to deposit tin dioxide, including spin-coating, chemical bath deposition, and magnetron sputtering. Among them, magnetron sputtering is one of the most mature industrial deposition techniques. However, PSCs based on magnetron-sputtered tin oxide (sp-SnO2) have a lower open -circuit voltage (Voc) and power conversion efficiency (PCE) than those prepared by the mainstream solution method. This is mainly due to the oxygen-related defects at the sp-SnO2/perovskite interface, and traditional passivation strategies usually have little effect on them. Herein, we successfully isolate the oxygen adsorption (Oads) defects located on the surface of sp-SnO2 from the perovskite layer using a PCBM double-electron transport layer. This isolation strategy effectively suppresses the Shockley-Read-Hall recombination at the sp-SnO2/perovskite interface, which results in an increase in the Voc from 0.93 to 1.15 V and an increase in PCE from 16.66 to 21.65%. To our knowledge, this is the highest PCE achieved using a magnetron-sputtered charge transport layer to date. The unencapsulated devices maintain 92% of their initial PCE after storage in air with a relative humidity of 30-50% after 750 h. We further use the solar cell capacitance simulator (1D-SCAPS) to confirm the effectiveness of the isolation strategy. This work highlights the application prospect of magnetron sputtering in the field of perovskite solar cells and provides a simple yet effective way to tackle the interfacial defect issue.Keywords
Funding Information
- National Key Research and Development Program of China (2020YFB1506400)
- National Natural Science Foundation of China (51711540302, 51773003, 52073002)
This publication has 64 references indexed in Scilit:
- Cost Analysis of Perovskite Tandem PhotovoltaicsJoule, 2018
- Low-Temperature Atomic Layer Deposition of Metal Oxide Layers for Perovskite Solar Cells with High Efficiency and Stability under Harsh Environmental ConditionsACS Applied Materials & Interfaces, 2018
- Scalable fabrication of perovskite solar cellsNature Reviews Materials, 2018
- Molecular engineering of conjugated polymers for efficient hole transport and defect passivation in perovskite solar cellsNano Energy, 2018
- Room-temperature processed tin oxide thin film as effective hole blocking layer for planar perovskite solar cellsApplied Surface Science, 2018
- A Breakthrough Efficiency of 19.9% Obtained in Inverted Perovskite Solar Cells by Using an Efficient Trap State Passivator Cu(thiourea)IJournal of the American Chemical Society, 2017
- Recombination in Perovskite Solar Cells: Significance of Grain Boundaries, Interface Traps, and Defect IonsACS Energy Letters, 2017
- Exploring the Way To Approach the Efficiency Limit of Perovskite Solar Cells by Drift-Diffusion ModelACS Photonics, 2017
- Achieving High Current Density of Perovskite Solar Cells by Modulating the Dominated Facets of Room-Temperature DC Magnetron Sputtered TiO2 Electron Extraction LayerACS Applied Materials & Interfaces, 2017
- Interplay between O2 and SnO2: Oxygen Ionosorption and Spectroscopic Evidence for Adsorbed OxygenChemphyschem, 2006