Form Characterization of Microhole Produced by Microelectrical Discharge Drilling
- 26 March 2009
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 24 (6) , 683-687
Abstract
This article discusses the characterization of form of microholes produced by microelectrical discharge drilling (micro-EDD) on beryllium-copper alloy using tungsten carbide electrode of 300 µm diameter. Using a fixed set of micro-EDD parameters, microholes of different aspect ratio were drilled. The selected form characteristics diameter, roundness, and taper angle were investigated. The hole diameter and roundness were estimated by using scanning electron microscope (SEM) and graphical calculation. The microhole was sectioned to measure the depth and taper angle. The variations of these form characteristics were plotted against aspect ratio. This experimental study showed that diameter, roundness error, and taper angle of the microhole increase with the increase of aspect ratio almost at the same rate. The electrode wear ratio was not insignificant for low aspect ratio microhole. However, it increased sharply with the increase of aspect ratio.Keywords
This publication has 21 references indexed in Scilit:
- Replication of Microlens Arrays by Gas-Assisted Hot EmbossingMaterials and Manufacturing Processes, 2008
- Geometry prediction of EDM-drilled holes and tool electrode shapes of micro-EDM process using simulationInternational Journal of Machine Tools and Manufacture, 2007
- Process simulation of micro electro-discharge machining on molybdenumJournal of Materials Processing Technology, 2007
- Micro-machining processes for microsystem technologyMicrosystem Technologies, 2006
- Sequential Laser and EDM Micro-drilling for Next Generation Fuel Injection Nozzle ManufactureCIRP Annals, 2006
- Analysis of Roundness Error and Surface Roughness in the Electro Jet Drilling ProcessMaterials and Manufacturing Processes, 2006
- A study on the characterization of high nickel alloy micro-holes using micro-EDM and their applicationsJournal of Materials Processing Technology, 2005
- Micro hole machining by conventional penetration electrical discharge machineInternational Journal of Machine Tools and Manufacture, 2003
- An experimental study on electro-discharge machining and polishing of high strength copper–beryllium alloysJournal of Materials Processing Technology, 2000
- The vibroscanning method for the measurement of micro-hole profilesMeasurement Science and Technology, 1999