Gradient Microstructure and Properties of Surface Mechanical Attrition–Treated AZ91D Alloy: An Effect of Colliding Balls Velocity
- 26 July 2023
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 25 (19)
Abstract
The surface properties of the AZ91D alloy are altered using surface mechanical attrition treatment (SMAT), a promising method of severe surface deformation, where the role of process parameters is crucial. In this study, specimens are SMATed using ≈3 and ≈10 m s−1 ball velocities (maintaining a constant percentage coverage). The SMATed specimens show higher twin density near the surface, which is reduced gradually, and twin thickness is increased with increasing depth. Further, high‐velocity balls cause more twin density and better grain refinement (≈32 nm grain size at the surface). The higher ball velocity helps form a considerably thicker gradient layer (≈3500 μm) with higher hardness (≈1.98 GPa) and compressive residual stress (≈281 MPa) within a shorter SMAT duration (≈10 min). Ball velocity also influences nanomechanical properties such as nanohardness, creep resistance, strain rate sensitivity (SRS), etc. The non‐SMATed alloy's SRS is about 0.037–0.040. The gradient microstructure affects SRS. The SRS value near the SMATed surface (where the reduced grain size plays a dominating role) is about 0.018–0.027; however, it drops suddenly to ≈0.01 (with a slight increase in depth), and subsequently, it rises with an increased distance in the SMATed layer (where twins play a dominating role).Keywords
This publication has 63 references indexed in Scilit:
- High-strain-rate nanoindentation behavior of fine-grained magnesium alloysJournal of Materials Research, 2012
- Nanocrystalline structure of magnesium alloys subjected to high energy shot peeningJournal of Alloys and Compounds, 2010
- EFFECT OF VELOCITY OF BALLS ON THE STRAIN AND STRESS OF LOW CARBON STEEL SURFACE LAYER DURING SMATInternational Journal of Modern Physics B, 2009
- Microstructure evolution of AZ91D induced by high energy shot peeningTransactions of Nonferrous Metals Society of China, 2008
- Wear behaviour of AZ91D magnesium alloy with a nanocrystalline surface layerSurface and Coatings Technology, 2008
- Characterization and properties of nanocrystalline surface layer in Mg alloy induced by surface mechanical attrition treatmentJournal of Alloys and Compounds, 2008
- Characterization of nanocrystalline ferrite produced by mechanical milling of pearlitic steelScripta Materialia, 2005
- Nitriding Iron at Lower TemperaturesScience, 2003
- Investigation of residual stress relaxation under cyclic loadInternational Journal of Fatigue, 2001
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992