Prediction of Moisture Loss in Withering Process of Tea Manufacturing Using Artificial Neural Network
- 12 October 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 67 (1) , 175-184
Abstract
The first and foremost process in tea manufacturing, withering, is the foundation for producing good quality. Moisture plays an important role in the manufacturing process of tea to get the desired quality. In this paper, a novel in situ instrumentation technique is proposed and validated experimentally for prediction of moisture loss (ML) in the withering process. In the proposed technique, ML is predicted based on the inlet and the outlet relative humidity (RH) and temperature during the process of withering. Network capable smart sensor nodes are developed for the measurement of RH and temperature at the inlet and outlet of the withering trough. Architecture of the nodes and network is described. A scaled-down prototype of an enclosed trough is developed to perform withering of tea leaves. Based on the data measured by the system, ML is predicted by using artificial neural network. Nonlinear autoregressive model with exogenous inputs is used for predicting the ML. The predicted ML is compared with the actual amount of ML measured by weight loss. A total of nine experiments are conducted for nine batches of tea leaves. The data collection, their analysis and results are reported in this paper. The observed result shows a good agreement between the predicted and actual ML. The maximum mean error in prediction is −3.6%.Keywords
This publication has 23 references indexed in Scilit:
- Use of Temperature and Humidity Sensors to Determine Moisture Content of Oolong TeaSensors, 2014
- Performance comparison of artificial neural network and logistic regression model for differentiating lung nodules on CT scansExpert Systems with Applications, 2012
- Simulation of Trough Withering of Tea using One Dimensional Heat and Mass Transfer Finite Difference ModelTropical Agricultural Research, 2011
- A new microstripline-type moisture sensor for heavily wet tea leavesMeasurement Science and Technology, 2007
- PC-Based Instrumentation System for the Detection of Moisture Content of Tea Leaves at Its Final StageIEEE Transactions on Instrumentation and Measurement, 2006
- Mathematical Modeling of Withering Characteristics of Tea LeavesDrying Technology, 2006
- A delay damage model selection algorithm for NARX neural networksIEEE Transactions on Signal Processing, 1997
- Learning long-term dependencies in NARX recurrent neural networksIEEE Transactions on Neural Networks, 1996
- Identification and control of dynamical systems using neural networksIEEE Transactions on Neural Networks, 1990
- Non-linear system identification using neural networksInternational Journal of Control, 1990