Strength, stiffness, and microstructure of Cu(In,Ga)Se2 thin films deposited via sputtering and co-evaporation
- 7 July 2014
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 105 (1) , 011907
Abstract
This work examines Cu(In,Ga)Se2 thin films fabricated by (1) selenization of pre-sputtered Cu-In-Ga and (2) co-evaporation of each constituent. The efficiency disparity between films deposited via these two methods is linked to differences in morphology and microstructure. Atomic force microscopy and scanning electron microscopy show that selenized films have rougher surfaces and poor adhesion to molybdenum back contact. Transmission electron microscopy and electron energy loss spectroscopy revealed multiple voids near the Mo layer in selenized films and a depletion of Na and Se around the voids. Residual stresses in co-evaporated films were found to be ∼1.23 GPa using wafer curvature measurements. Uniaxial compression experiments on 500 nm-diameter nanopillars carved out from co-evaporated films revealed the elastic modulus of 70.4 ± 6.5 GPa. Hertzian contact model applied to nanoindentation data on selenized films revealed the indentation modulus of 68.9 ± 12.4 GPa, which is in agreement with previous reports. This equivalence of the elastic moduli suggests that microstructural differences manifest themselves after the yield point. Typical plastic behavior with two distinct failure modes is observed in the extracted stress-strain results, with the yield strength of 640.9 ± 13.7 MPa for pillars that failed by shearing and 1100.8 ± 77.8 MPa for pillars that failed by shattering.Keywords
This publication has 25 references indexed in Scilit:
- Effect of sodium incorporation into CuInSe2 from first principlesJournal of Applied Physics, 2013
- New world record efficiency for Cu(In,Ga)Se2 thin‐film solar cells beyond 20%Progress in Photovoltaics: Research and Applications, 2011
- CIGS absorbers and processesProgress in Photovoltaics: Research and Applications, 2010
- Roles of sodium induced defects in CuInSe2 by first principles calculationComputational Materials Science, 2009
- Uniaxial compression of fcc Au nanopillars on an MgO substrate: The effects of prestraining and annealingActa Materialia, 2009
- Formation and characterisation of MoSe2 for Cu(In,Ga)Se2 based solar cellsThin Solid Films, 2005
- Size dependence of mechanical properties of gold at the micron scale in the absence of strain gradientsActa Materialia, 2005
- Microhardness-bulk modulus scaling and pressure-induced phase transformations in AIBIIIC2VI chalcopyrite compoundsJournal of Applied Physics, 1999
- Improved compositional flexibility of Cu(In,Ga)Se2-based thin film solar cells by sodium control techniqueSolar Energy Materials and Solar Cells, 1997
- The tension of metallic films deposited by electrolysisProceedings of the Royal Society of London. Series A, Containing Papers of a Mathematical and Physical Character, 1909