Rheological Analysis of Modified Bitumen by PVC Based Various Recycled Plastics
- 1 December 2020
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering, Part B: Pavements
- Vol. 146 (4) , 04020063
Abstract
The aim of this paper is to examine the rheological behavior of bitumen modified by three waste plastics (old window frames, blinds, and cables) which are composed of polyvinyl chloride (PVC). Thus, nine polymer-modified bitumen samples were produced by adding the PVC-based modifiers to bitumen at three different contents (2%, 4%, and 6%).The rheological properties of the pure and modified bitumens were analyzed by means of conventional and rotational viscosity (RV) tests as well as the dynamic shear rheometer (DSR) test. The DSR test was performed at three different frequencies representing three different traffic speeds on highways. Master curves of complex viscosity and complex modulus of modified bitumens were plotted using the data obtained from DSR test results. After polymer modification, it was observed that all modified binders behaved like Newtonian fluid, especially at lower angular frequencies. The results of the tests indicate that waste blind modification has a certain stiffening effect on bitumen. However, it provides a higher complex modulus and a lower phase angle at all traffic speeds. Modification using waste blinds of more than 4% caused difficult workability of the bitumen. This means that, by using plastic blind waste as a modifier with a 4% usage rate, it is possible to decrease wheel-tracking deformation, which is fundamental for the extension of pavement life.Keywords
This publication has 16 references indexed in Scilit:
- A sustainable approach: Utilization of waste PVC in asphalting of roadsConstruction and Building Materials, 2014
- Effect of polymer modifiers on the properties of bitumenJournal of Elastomers & Plastics, 2013
- Performance Evaluation of Waste Polyethylene and PVC on Hot Asphalt MixturesAmerican Journal of Civil Engineering and Architecture, 2013
- A technique to dispose waste plastics in an ecofriendly way – Application in construction of flexible pavementsConstruction and Building Materials, 2012
- The effect of asphaltene on thermal properties of bitumenChemical Engineering Research and Design, 2011
- Mechanical properties of recycled PVC blends with styrenic polymersJournal of Applied Polymer Science, 2006
- Rheological properties of styrene butadiene styrene polymer modified road bitumens⋆Fuel, 2003
- Influence of the processing conditions on the rheological behaviour of polymer-modified bitumen$star;*1Fuel, 2003
- Modification of road bitumens with thermoplastic polymersPolymer Testing, 2000
- The Temperature Dependence of Relaxation Mechanisms in Amorphous Polymers and Other Glass-forming LiquidsJournal of the American Chemical Society, 1955