Inexpensive Kinematic Attitude Determination from MEMS-Based Accelerometers and GPS-Derived Accelerations
Authors:
- 1 September 2002
- journal article
- research article
- Published by Institute of Navigation in NAVIGATION: Journal of the Institute of Navigation
- Vol. 49 (3) , 117-126
Abstract
This paper describes an inexpensive kinematic attitude determination technique that uses GPS and a triaxial accelerometer. By removing the GPS-derived accelerations from the specific forces sensed by the accelerometers, the gravity vector in body frame of the vehicle is determined. From this, roll and pitch can be calculated. Azimuth is provided by the GPS-measured trajectory. Details are given on the system components and configuration, and on the kinematic attitude determination algorithm. A test of the technique shows that the root-mean-square (RMS) error is less than 1 deg. An analysis of Taylor series finite-difference differentiators in the frequency domain is also given. From this analysis, it is shown that for second derivatives, direct differentiators are preferable to cascaded differentiators unless the suppression of high frequencies is desired.Keywords
This publication has 3 references indexed in Scilit:
- Differentiation for High-Precision GPS Velocity and Acceleration DeterminationGPS Solutions, 1999
- GPS phase accelerations for moving-base vector gravimetryJournal of Geodesy, 1997
- DGPS Kinematic Carrier Phase Signal Simulation Analysis for Precise Velocity and Position DeterminationNAVIGATION: Journal of the Institute of Navigation, 1997