Fabrication and investigation of influence of CaCO 3 as foaming agent on Al-SiCp foam
- 13 November 2018
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 34 (4) , 379-384
Abstract
Closed cell aluminum foams have been used in various disciplines of engineering. Aluminum foams provide high strength with the advantage of low weight. In the current research, CaCO3 is used as a foaming agent for producing closed-cell aluminum foams. For the fabrication of homogenous foam, optimization of process parameters was done. The effect of SiC as a thickening agent on structural property of foams viz. density and porosity have been inspected. Foams with density 0.40–0.86 g/cm3 were produced. The produced foams were studied under axial compression tests for evaluating mechanical properties. It can be inferred from the results that by adding 3 wt.% CaCO3, the uniform viscosity of melt was achieved and a homogeneous foam structure is achieved with optimum porosity. Also, 5 wt.% addition of CaCO3 in melt and stirring speed at 1400 rpm tend to increase porosity and decrease cell wall thickness. The optimum values for thickening agent SiC, foaming agent CaCO3 at stirring speed 1400 rpm were found out to be 15 wt.%, 3 wt.%. The effect of relative density, the addition of thickening and foaming agent is studied.Keywords
This publication has 18 references indexed in Scilit:
- Fabrication of aluminum alloy foams by using alternative thickening agents via melt routeJournal of Alloys and Compounds, 2017
- Nano-SiCp effects on the production, microstructural evolution and compressive properties of highly porous Al/CaCO3 foam fabricated via continual annealing and roll-bonding processMaterials Science and Engineering: A, 2017
- An Investigation on Axial Deformation Behavior of Thin-Wall Unfilled and Filled Tube with Aluminum Alloy (Al-Si7Mg) Foam Reinforced with SiC ParticlesJournal of Materials Engineering and Performance, 2016
- Investigation and characterisation of aluminium alloy foams with TiH2 as a foaming agentMaterials Science and Technology, 2016
- Manufacturing of Al–Mg–Si alloy foam using calcium carbonate as foaming agentJournal of Materials Processing Technology, 2009
- Aluminium foams for lighter vehiclesInternational Journal of Vehicle Design, 2005
- The FOAMCARP process: foaming of aluminium MMCs by the chalk-aluminium reaction in precursorsComposites Science and Technology, 2003
- Development of New Foaming Agent for Metal FoamMATERIALS TRANSACTIONS, 2002
- Deformation characteristics of metal foamsJournal of Materials Science, 1998
- Damping properties of aluminium foamsMaterials Science and Engineering: A, 1996