Friction-reducing contact area expansion in upsetting
Author:
- 1 February 2001
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 215 (2) , 189-200
Abstract
The most obvious problem in static and dynamic upsetting is dealing with the effects of friction. In upsetting with friction, the final contact area can be divided into two parts: the expanded original contact area and the immigrated contact area. In this paper, upsetting of aluminium alloy AA 6082, low-carbon steel W. No. 1.0303 and stainless steel W. No. 1.4301 with three kinds of machined end surface lubricated by five different lubricants is carried out. Finite element analyses applying five different friction models are performed to estimate the contact areas and metal flows. Contact area configurations and two parameters, namely the friction area ratio and immigrated contact area ratio, are suggested. The influences of reduction, lubrication and temperature on the contact areas are experimentally and theoretically investigated. It is found that reducing the contact area expansion is a basic characteristic of friction in upsetting by both experiments and finite element method simulations.Keywords
This publication has 23 references indexed in Scilit:
- Friction studies at different normal pressures with alternative ring-compression testsJournal of Materials Processing Technology, 1998
- Evaluation of friction in cold metal formingJournal of Materials Processing Technology, 1994
- The Evaluation of Flow Stress and Friction in Upsetting of Rings and CylindersCIRP Annals, 1993
- A review of ring-compression testing and applicability of the calibration curvesJournal of Materials Processing Technology, 1993
- Factors Affecting the Double Cup Extrusion Test for Evaluation of Friction in Cold and Warm ForgingCIRP Annals, 1993
- Evaluation of lubrication and friction in cold forging using a double backward-extrusion processJournal of Materials Processing Technology, 1992
- An Approximate Model to Calculate Foldover and Strains During Cold Upsetting of Cylinders Part I: Formulation and Evaluation of the Foldover ModelJournal of Engineering for Industry, 1990
- Analysis of the Ring Test Method for the Evaluation of Frictional Stresses in Bulk Metal Forming ProcessesCIRP Annals, 1988
- Prediction of the Geometry Changes of the Free Boundary During Upsetting by the Slip-Line TheoryJournal of Engineering for Industry, 1971
- Some analytical and experimental studies of axi-symmetric cold forging and extrusion—IInternational Journal of Mechanical Sciences, 1960