Synthesized Hybrid CNT Polymer Composite in Reducing EMI Pollution at Gigahertz Frequency Range
Open Access
- 13 May 2025
- journal article
- Published by Akademia Baru Publishing in Semarak International Journal of Nanotechnology
- Vol. 1 (1) , 1-12
Abstract
Modern digital systems are seriously impacted by the electromagnetic (EM) danger caused by various EM wave that interfere one another, either internally or externally. The electromagnetic interference (EMI) pollution has become an attention among researchers since it not only affects the devices, but also affecting human and biological systems. Thus, synthesizing an EM wave absorber that able to absorb the unwanted EM wave signal is crucial. This research highlight on the materials’ properties and characterization of the synthesized nanometer size hybrid Carbon Nanotubes (CNTs) of individual ferrite (Ni0.5Zn0.5Fe2O4 or Carbonyl iron) and mixed ferrite (Ni0.5Zn0.5Fe2O4 + Carbonyl iron) as catalyst to grow CNTs by using Chemical Vapour Deposition (CVD) method. The synthesized hybrid CNTs used as fillers were mixed with epoxy resin and hardener as the matrix at certain ratio of thickness fixed at 1 mm, 2 mm, and 3 mm. The hybrid CNTs was analysed by using X-ray diffractometer (XRD), a Field emission Scanning Electron Microscope (FeSEM) and RAMAN spectrometer to determine the phase formation, microstructural and structural analysis respectively. On the other hand, the Vector Network Analyzer (VNA) measured at 8 to 18 GHz frequency range was used to measure and analyse the microwave characterization. The phase analysis confirmed the existence of Carbon and Iron Carbide, whereas the microstructural shows the synthesized hybrid CNTs are mostly straight like, twisted and spiral fiber. Moreover, the structural analysis shows more defective structure with the formation of multiwalled CNTs that helps in absorbing the EM wave. The reflection loss (RL) of the growth individual Ni0.5Zn0.5Fe2O4 and Carbonyl Iron shows the RL value of -18 dB and -15 dB of thickness 2 mm respectively. The RL result also show improvement in the RL values for the growth of mixed ferrite with RL reach until -26 dB (thickness=3mm). Consequently, it indicates that using both single and mixed ferrite as a catalyst to grow CNT produces better EM wave performance appropriate for various applications.Keywords
This publication has 27 references indexed in Scilit:
- Research advances in composition, structure and mechanisms of microwave absorbing materialsComposites Part B: Engineering, 2021
- Construction of 2D/0D/2D Face-to-Face Contact g-C3N4@Au@Bi4Ti3O12 Heterojunction Photocatalysts for Degradation of Rhodamine BJournal of Electronic Materials, 2020
- Dedications2013
- Increasing the electrical conductivity of carbon nanotube/polymer composites by using weak nanotube–polymer interactionsCarbon, 2010
- Microwave absorption properties of one thin sheet employing carbonyl–iron powder and chlorinated polyethyleneJournal of Magnetism and Magnetic Materials, 2010
- Analysis of the structure and chemical properties of some commercial carbon nanostructuresCarbon, 2009
- Absorbing properties and structural design of microwave absorbers based on carbonyl iron and barium ferriteJournal of Magnetism and Magnetic Materials, 2007
- The effect of processing conditions on carbon nanostructures formed on an iron-based catalystCarbon, 2006
- Carbon nanotube synthesis and parametric study using CaCO3 nanocrystals as catalyst support by CVDMaterials Chemistry and Physics, 2006
- Electron Microscopy of Nanotubes2003