Fabrication of micro rod electrode by electrical discharge grinding using two block electrodes
Authors:
- Yin QingfengYQYin Qingfeng
- Wang XingqiaoWXWang Xingqiao
- Wang PingWPWang Ping
- Qian ZhiqiangQZQian Zhiqiang
- Zhou LinZLZhou Lin
- Zhang YongbinZYZhang Yongbin
- 1 August 2016
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 234, 143-149
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- Precision machining of micro tool electrodes in micro EDM for drilling array micro holesPrecision Engineering, 2015
- EDM turning using a strip electrodeJournal of Materials Processing Technology, 2013
- Influence of vibration on micro-tool fabrication by electrochemical machiningInternational Journal of Machine Tools and Manufacture, 2013
- High-aspect ratio micro-pin manufacturing using inverse slab electrical discharge milling (ISEDM) processThe International Journal of Advanced Manufacturing Technology, 2012
- Analysis of Micro-Pin Manufacturing Using Inverse Slab Electrical Discharge Milling (ISEDM) ProcessKey Engineering Materials, 2011
- The analysis and investigation on the microelectrode fabrication by electrochemical machiningInternational Journal of Machine Tools and Manufacture, 2009
- Preparation of a needle probe with a sharp tip and high aspect ratio geometry by an electrochemical etching methodCorrosion Science, 2006
- Micro-pin Electrodes Formation by Micro-Scanning EDM ProcessCIRP Annals, 2006
- EDM of micro-rods by self-drilled holesJournal of Materials Processing Technology, 2004
- Wire Electro-Discharge Grinding for Micro-MachiningCIRP Annals, 1985