Microstructure and Electrical Property of Ex-Situ and In-Situ Copper Titanium Carbide Nanocomposites
Open Access
Abstract
In this study, ex-situ Cu-TiC nanocomposites of 1, 3 and 5 vol. % TiC and in-situ Cu-TiH2-C nanocomposites (corresponding to 5 vol. % TiC) were prepared using ball milling and spark plasma sintering methods. Powder mixtures were milled for 4 h at 400 rpm. As-milled Cu-TiC composite powders were consolidated under an applied pressure of 70 MPa. The phase composition, and microstructure of the composite samples were characterized by X-ray diffraction, and scanning electron microscope and transmission electron microscope techniques, respectively. With the increasing TiC content from 1 to 5 vol. %, the hardness of the ex-situ composites when sintered at 600 °C changed between 161.4 and 178.5 HV and the electrical conductivity decreased from 52.1 to 47.6% IACS. In-situ Cu-TiH2-C nanocomposite sintered at 950 °C had higher hardness and electrical conductivity than ex-situ Cu-TiC composite due to having a homogenous distribution of nano reinforcement particles and dense structure.Keywords
Funding Information
- National Foundation for Science and Technology Development (103.02-2017.366)
This publication has 32 references indexed in Scilit:
- Investigation of microstructure, hardness and wear properties of Al–4.5wt.% Cu–TiC nanocomposites produced by mechanical millingMaterials & Design (1980-2015), 2011
- The effect of sintering temperature on some properties of Cu–SiC compositeJournal of Alloys and Compounds, 2011
- Development of high strength, high conductivity copper by friction stir processingMaterials & Design (1980-2015), 2011
- Spark plasma sintering of mechanically alloyed in situ copper–niobium carbide compositeJournal of Alloys and Compounds, 2010
- The Influence of Technological Process on Dry Sliding Wear Behaviour of Titanium Carbide Reinforcement Copper Matrix CompositesMATERIALS TRANSACTIONS, 2010
- Consolidation of dispersion strengthened copper–niobium carbide composite prepared by in situ and ex situ methodsMaterials Science and Engineering: A, 2009
- Microstructure, mechanical, and electrical properties of Cu–Ti3AlC2 and in situ Cu–TiCx compositesJournal of Materials Research, 2008
- Mechanical and electrical properties of Cu–Ta nanocomposites prepared by high-energy ball millingActa Materialia, 2007
- Al-La-Ni-Fe bulk metallic glasses produced by mechanical alloying and spark-plasma sinteringMaterials Science and Engineering: A, 2007
- Microstructural and mechanical characteristics of in situ metal matrix compositesMaterials Science and Engineering: R: Reports, 2000