Metrology of infrared superconducting bolometers with a backshort
Open Access
- 1 May 2023
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (5)
Abstract
We present the detailed metrology of a superconducting Transition-Edge Sensor (TES) absorber-coupled bolometer array bonded to a variable-delay backshort to form an integral field unit. The backshort is shaped as a wedge to continuously vary the electrical phase delay of the bolometer absorber reflective termination across the array. This resonant absorber termination structure is used to define a spectral response over a 4:1 bandwidth in the far-infrared, from ∼30 to 120 μm. The metrology of the backshort-bolometer array hybrid was achieved with a laser confocal microscope and a compact cryogenic system that provides a well-defined thermal (radiative and conductive) environment for the hybrid when cooled to ∼10 K. The results show the backshort free-space delays do not change with cooling. The estimated backshort slope is 1.58 milli-radians and within 0.3% of the targeted value. The sources of error in the free-space delay of the hybrid and optical cryogenic metrology implementations are discussed in detail. We also present measurements of the bolometer’s single-crystal silicon membrane topography. The membranes deform and deflect out-of-plane under both warm and cold conditions. Intriguingly, the optically active area of the membranes tends to flatten when cold and repeatably achieve the same mechanical state over many thermal cycles; hence, no evidence for thermally-induced mechanical instability is observed. Most of the cold deformation is sourced from thermally-induced stress in the metallic layers comprising the TES element of the bolometer pixels. These results provide important considerations for the design of ultra-low-noise TES bolometers.Keywords
Funding Information
- National Aeronautics and Space Administration (SOFIA-15-S3GSI15-2-0003, SAT-20-SMDSS20-0022)
- Astrophysics Science Division (IRAD-22-8)
This publication has 31 references indexed in Scilit:
- Toward a Detector/Readout Architecture for the Background-Limited Far-IR/Submm Spectrograph (BLISS)Journal of Low Temperature Physics, 2014
- SCUBA-2: the 10 000 pixel bolometer camera on the James Clerk Maxwell TelescopeMonthly Notices of the Royal Astronomical Society, 2013
- Diffraction Considerations for Planar Detectors in the Few-Mode LimitPublications of the Astronomical Society of the Pacific, 2008
- Thermal filtering for large aperture cryogenic detector arrays2006
- Cryogenic characterization and testing of magnetically-actuated microshutter arrays for the James Webb Space TelescopeJournal of Micromechanics and Microengineering, 2005
- Robust infrared filters for X-ray spectroscopyNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2004
- Optical properties of the metals Al, Co, Cu, Au, Fe, Pb, Ni, Pd, Pt, Ag, Ti, and W in the infrared and far infraredApplied Optics, 1983
- Absorption of composite bolometersJournal of the Optical Society of America, 1981
- Bandpass Filters Using Parallel Coupled Stripline Stepped Impedance ResonatorsIEEE Transactions on Microwave Theory and Techniques, 1980
- Flow Areas for Series-Parallel Compartment Venting to Satisfy Pressure Differential RequirementsJournal of Spacecraft and Rockets, 1973