Shrinkage effects during polymer phase separation on microfabricated molds
Authors:
- Matías BikelMBMatías Bikel
- I.G.M. PüntIPI.G.M. Pünt
- R.G.H. LammertinkRLR.G.H. Lammertink
- M. WesslingMWM. Wessling
- 1 February 2010
- journal article
- Published by Elsevier in Journal of Membrane Science
- Vol. 347 (1-2) , 141-149
Abstract
No abstract availableKeywords
This publication has 21 references indexed in Scilit:
- One-step fabrication of porous micropatterned scaffolds to control cell behaviorBiomaterials, 2007
- The role of the nature of the casting substrate on the properties of membranes prepared via immersion precipitationJournal of Membrane Science, 2006
- Polymeric microsieves produced by phase separation micromoldingJournal of Membrane Science, 2006
- New replication technique for the fabrication of thin polymeric microfluidic devices with tunable porosityLab on a Chip, 2005
- Phase Separation Micromolding: A New Generic Approach for Microstructuring Various MaterialsSmall, 2005
- Wet‐phase‐separation membranes from the polysulfone/N,N‐dimethylacetamide/water ternary system: The formation and elements of their structure and propertiesJournal of Applied Polymer Science, 2005
- The wet phase separation: the effect of cast solution thickness on the appearance of macrovoids in the membrane forming ternary cellulose acetate/acetone/water systemJournal of Membrane Science, 2002
- Phase behavior and mechanism of membrane formation for polyimide/DMSO/water systemJournal of Membrane Science, 2001
- Polymeric membrane formation by wet-phase separation; turbidity and shrinkage phenomena as evidence for the elementary processesPolymer, 2000
- Diffusion induced phase separation with crystallizable nylons. I. Mass transfer processes for nylon 4,6Journal of Membrane Science, 1996