Influence of different high pressure die casting processes on 3D porosity distribution of Mg-3.0Nd-0.3Zn-0.6Zr alloy
Authors:
- 1 November 2021
- journal article
- research article
- Published by Springer Nature in China Foundry
- Vol. 18 (6) , 521-528
Abstract
No abstract availableKeywords
This publication has 19 references indexed in Scilit:
- Relationship Between the 3D Porosity and β-Phase Distributions and the Mechanical Properties of a High Pressure Die Cast AZ91 Mg AlloyMetallurgical and Materials Transactions A, 2013
- Microstructure, mechanical properties, biocorrosion behavior, and cytotoxicity of as-extruded Mg–Nd–Zn–Zr alloy with different extrusion ratiosJournal of the Mechanical Behavior of Biomedical Materials, 2012
- Effects of shot speed and biscuit thickness on externaly solidified crystals of high-pressure diet cast AM60B magnesium alloyTransactions of Nonferrous Metals Society of China, 2011
- Microstructures and mechanical properties of heat-resistant high-pressure die-cast Mg–4Al–xLa–0.3Mn (x=1, 2, 4, 6) alloysMaterials Science and Engineering: A, 2010
- The correlation between microstructure and mechanical properties of high-pressure die-cast AM50 alloyJournal of Alloys and Compounds, 2009
- Formation of gas induced shrinkage porosity in Mg-alloy high-pressure die-castingsScripta Materialia, 2006
- Quantitative fractographic analysis of variability in the tensile ductility of high-pressure die-cast AE44 Mg-alloyMaterials Science and Engineering: A, 2006
- Effect of process parameters on porosity distributions in high-pressure die-cast AM50 Mg-alloyMaterials Science and Engineering: A, 2006
- Variability in the tensile ductility of high-pressure die-cast AM50 Mg-alloyScripta Materialia, 2005
- Relationship between internal porosity and fracture strength of die-cast magnesium AM60B alloyMaterials Science and Engineering: A, 2005