Design and Fabrication of a Four-Arm-Structure MEMS Gripper
Authors:
- Tao ChenTCTao Chen
- Liguo ChenLCLiguo Chen
- Lining SunLSLining Sun
- Xinxin LiXLXinxin Li
- 23 September 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 56 (4) , 996-1004
Abstract
This paper is focused on the design and fabrication of a four-arm-structure microelectromechanical systems gripper integrated with sidewall piezoresistive force sensors. Surface and bulk micromachining technologies are employed to fabricate the microgripper from a single-crystal silicon wafer (i.e., no silicon-on-insulator wafer is used). A vertical sidewall surface piezoresistor etching technique is used to form the side direction force sensors. The end effector of this gripper is a four-arm structure: two fixed cantilever arms integrated with piezoresistive sensors are designed to sense the gripping force. The resolution of the force sensor is in the micronewton range and, therefore, provides feedback of the forces that dominate the micromanipulation processes. An electrostatically driven microactuator is designed to provide the force to operate the other two movable arms. In this way, it creates a deflection of 25 mum at the arm tip, and the range of the operation is 30-130 mum. Experimental results show that it can successfully provide force sensing and play a main role in preventing the damage of microparts in micromanipulation and microassembly tasks.Keywords
This publication has 21 references indexed in Scilit:
- Light-Intensity-Feedback-Waveform Generator Based on MEMS Variable Optical AttenuatorIEEE Transactions on Industrial Electronics, 2008
- Command-Shaping Techniques for Electrostatic MEMS Actuation: Analysis and SimulationJournal of Microelectromechanical Systems, 2007
- Design and fabrication of an electrostatically driven microgripper for blood vessel manipulationMicroelectronic Engineering, 2006
- Fabrication of the micro-gripper with a force sensor for manipulating a cell2006
- Design, fabrication, and testing of a 3-DOF HARM micromanipulator on (111) silicon substrateSensors and Actuators A: Physical, 2005
- Microassembly Experiments With Transparent Electrostatic Gripper Under Optical and Vision-Based ControlIEEE Transactions on Industrial Electronics, 2005
- Micro manipulation based on micro physics-strategy based on attractive force reduction and stress measurement2002
- Electrostatically driven microgripperMicroelectronic Engineering, 2002
- Integrated microendeffector for micromanipulationIEEE/ASME Transactions on Mechatronics, 1998
- Polysilicon microgripperSensors and Actuators A: Physical, 1992