Closed Loop Control Design of Two Inductor Current-Fed Isolated DC-DC Converter for Fuel Cells to Utility Interface Application
Authors:
- A. K. RathoreARA. K. Rathore
- A. K. S. BhatABA. K. S. Bhat
- S. NandiSNS. Nandi
- Ramseh OrugantiRORamseh Oruganti
- 1 October 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Abstract
This paper presents a closed loop control design for a two inductor active-clamped ZVS current-fed isolated DC-DC converter using two-loop average current control. State-space averaging technique is used to derive the small signal model. The controller is designed for fixed frequency duty cycle modulation and works for wide input voltage and load variation. A complete design procedure is presented. Experimental results for step- change in load are presented at different input voltage conditions.Keywords
This publication has 13 references indexed in Scilit:
- Analysis and design of active clamped ZVS current-fed DC-DC converter for fuel-cell to utility-interface application2007
- A New Active Clamping Zero-Voltage Switching PWM Current-Fed Half-Bridge ConverterIEEE Transactions on Power Electronics, 2005
- Predictive controller for interleaved boost converter2005
- Predictive valley current control for two inductor boost converter2005
- High-Frequency Link Inverter for Fuel Cells Based on Multiple-Carrier PWMIEEE Transactions on Power Electronics, 2004
- High performance predictive dead-beat digital controller for DC power suppliesIEEE Transactions on Power Electronics, 2002
- Design issues for digital control of boost power factor correction converters2002
- Fast controller design for single-phase power-factor correction systemsIEEE Transactions on Industrial Electronics, 1997
- Design of a simple high-power-factor rectifier based on the flyback converter1990
- Modern DC-to-DC Switchmode Power Converter Circuits1985