Bonding of one-step and two-step self-etching primer adhesives to dentin with different tubule orientations
Authors:
- Olabisi Asande AdebayoOAOlabisi Asande Adebayo
- Michael Francis BurrowMBMichael Francis Burrow
- Martin John TyasMTMartin John Tyas
- 1 January 2008
- journal article
- research article
- Published by Medical Journals Sweden AB in Acta Odontologica Scandinavica
- Vol. 66 (3) , 159-168
Abstract
To determine the microshear bond strengths of five 'all-in-one' adhesives and two 2-step self-etching primer adhesives to dentin with different tubule orientations and to compare bond strengths between the adhesives. Human adult molar teeth were sectioned to obtain dentin pieces with tubule orientations perpendicular or parallel/oblique to the bonded surface. Two 2-step self-etching primer adhesives (Clearfil SE Bond (CSE), Optibond Solo Plus SE Bond (Op. SE)) and five all-in-one adhesives (Clearfil S(3) Bond (S(3)), Optibond All-in-One Bond (Op. AIO), G-Bond, Go!, and Xeno IV) were applied to dentin in accordance with the manufacturers' instructions. Resin composite cylinders were bonded to superficial and deep dentin using microtubes (0.75 mm internal diameter and 1.5 mm high). Bonded specimens were stored in water at 37 degrees C for 24 h, then stressed in shear at a cross-head speed of 1 mm/min until bond failure. Maximum load at failure (N) was recorded and converted to MPa. Statistical analyses were carried out using independent samples t-test and one-way ANOVA with Tukey's HSD test. Though bond strengths varied slightly, four all-in-one adhesives (Op. AIO, G-Bond, Go!, and Xeno IV) showed no significant differences in microshear bond strengths regardless of dentin depth (superficial or deep) or dentin tubule orientation (perpendicular or parallel/oblique). CSE, Op. SE, and S(3) showed significantly lower bond strengths to deep dentin with a tubule orientation perpendicular to the surface. Most of the all-in-one adhesive systems used in this study appear to bond equally well to dentin independently of tubule orientation and depth. One two-step self-etching primer adhesive bonded significantly better than the all-in-one adhesives.Keywords
This publication has 20 references indexed in Scilit:
- Systematic review of the chemical composition of contemporary dental adhesivesBiomaterials, 2007
- Effect of simulated pulpal pressure on dentin permeability and adhesion of self-etch adhesivesDental Materials, 2007
- Bond Strength of Different Adhesive Systems to Dental Hard TissuesOperative Dentistry, 2007
- Bonding characteristics of newly developed all‐in‐one adhesivesJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2006
- Degree of conversion and permeability of dental adhesivesEuropean Journal of Oral Sciences, 2005
- Chemical aspects of self-etching enamel–dentin adhesives: A systematic reviewDental Materials, 2005
- Adhesive restorative materials: A reviewAustralian Dental Journal, 2004
- The effect of dentine location and tubule orientation on the bond strengths between resin and dentineJournal of Dentistry, 1999
- Dentin shear strength: Effects of tubule orientation and intratooth locationDental Materials, 1996
- Correlation among dentin depth, permeability, and bond strength of adhesive resinsDental Materials, 1990