Reliability of Cu Wire Bonding to Al Metallization
Authors:
- 1 January 2007
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 05695503,p. 1604-1613
Abstract
The use of Cu wire for thermosonic ball bonding presents several advantages over Au wire. These advantages include significant cost savings due to cheaper raw material cost, higher electrical conductivity for faster die functionality, and much slower intermetallic compound (IMC) growth than Au wire. There are still some challenges that must be overcome, however, before Cu wire bonding can be successful. Since Cu is much harder than Au there is the potential to cause damage to the bond pad or other underlying layers of the die. Oxidation of the Cu wire can also act to inhibit second bond formation, which can result in increased wire bond no-stick rates. Cu oxidation can also result in a very short spool lifetime once the wire has been exposed to the atmosphere. This study focuses on the manufacturability and reliability of using Cu wire for ball bonding in a high volume DRAM production environment. Wire bonding first bond parameters were optimized, and the process was characterized through bond integrity testing (BIT). Package reliability was determined through environmental tests that included HAST, T/C-B, and HTS. IMC growth in the Al-Cu system was characterized and compared to the Al-Au system. Electrical test data of live packages bonded with Cu wire was also compared to that of packages bonded with Au wire to determine if there was any amount of performance or DRAM refresh degradation caused by the Cu wire. This was done at both the individual package level and module level.Keywords
This publication has 7 references indexed in Scilit:
- Acid Decapsulation of Epoxy Molded IC Packages With Copper Wire BondsIEEE Transactions on Electronics Packaging Manufacturing, 2006
- High Temperature Storage (HTS) Performance of Copper Ball Bonding Wires2006
- Characterisation of intermetallic growth in copper and gold ball bonds on aluminium metallization2005
- Effects of Cu/Al intermetallic compound (IMC) on copper wire and aluminum pad bondabilityIEEE Transactions on Components and Packaging Technologies, 2003
- Optimization of copper wire bonding on Al-Cu metallizationIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 1995
- Interdiffusion in copper–aluminum thin film bilayers. II. Analysis of marker motion during sequential compound formationJournal of Applied Physics, 1983
- Interdiffusion in copper–aluminum thin film bilayers. I. Structure and kinetics of sequential compound formationJournal of Applied Physics, 1983