A unified expression to estimate the stress-strain curve of polyamides at different temperatures
- 1 October 2018
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (1) , 015304
Abstract
The present paper proposes a unified expression to estimate the mechanical behaviour of polyamides in tensile tests at different temperatures. The goal is to present an algebraic equation able to describe the stress-strain curves that would be obtained using the ASTM D638-14 standard for a wide range of temperatures (roughly from -30 oC to 90 oC, even above the Glass Transition Temperature). This expression is valid for different kinds of polyamides. It is shown that with a minimum of three tests performed at different temperatures, it is possible to obtain a reasonable approximation of the stress-strain curve for this range of temperatures. Examples are presented considering different types of polyamides – PA11, PA12 and PA66-GF30 (PA66 reinforced with 30 wt% of short glass fibres). Although the mechanical behaviour is strongly affected by temperature variation, the estimates of the material behaviour are in good agreement with experiments in all cases studied in this paper. Such a procedure can be a practical tool for designers, used to obtain a reasonable approximation of tensile tests and thus reducing the need of performing many complex experiments.Keywords
This publication has 18 references indexed in Scilit:
- Influence of temperature on the behavior of DGEBA (bisphenol A diglycidyl ether) epoxy adhesiveInternational Journal of Adhesion and Adhesives, 2015
- Aging of polyamide 11. Part 1: Evaluating degradation by thermal, mechanical, and viscometric analysisJournal of Applied Polymer Science, 2015
- Influence of the temperature and strain rate on the tensile behavior of post-consumer recycled high-density polyethylenePolymer Testing, 2013
- Some remarks about the use of Gordon–Schowalter time derivative in rate-type viscoelastic constitutive equationsInternational Journal of Engineering Science, 2013
- Tensile properties of semi-crystalline thermoplastic polymers: Effects of temperature and strain ratesPolymer Testing, 2013
- On thermodynamics, objectivity and the modeling of non-isothermal viscoelastic fluid behaviorNonlinear Analysis: Real World Applications, 2012
- Analysis of burst tests and long-term hydrostatic tests in produced water pipelinesEngineering Failure Analysis, 2012
- Environment-friendly synthesis of long chain semiaromatic polyamidesExpress Polymer Letters, 2009
- Injection moulding of long glass fibre reinforced polyamide 6-6: guidelines to improve flexural propertiesExpress Polymer Letters, 2007
- A thermodynamically consistent constitutive theory for fluidsInternational Journal of Non-Linear Mechanics, 1998